Notes

What Is The Reason Peugeot Keys Is The Right Choice For You?
Peugeot 208 Key Replacement

It is better to leave the replacement of Peugeot 208 keys to auto locksmiths equipped with the required equipment and know-how. They can create and program new keys faster than a dealership would and at a cheaper cost.

A dead battery for your coin is most likely to be the cause the reason why your key fob isn't locking or unlocking doors. There are many other reasons that the key might be malfunctioning.

Dead Coin Battery

A dead battery in the coin compartment will hinder your Peugeot 208 from locking or unlocking and cannot start the engine. In this scenario you'll need make use of the alternative method for starting found in your vehicle's owner's manual.

The spark plugs might also be worn out. The spark plugs ignite fuel to start the engine. They are only able to last for a short time. If they aren't utilized enough and they fail, they'll eventually die.

Luckily, there is an easy solution to this problem. Examine the voltage of your battery using a multimeter. If the voltage is lower than 11,5 volts, it's the time to replace it. If the battery is damaged it is crucial to clean its contacts. This can be done by lifting the rubber covers that cover the two terminals of the battery and using a wire brush to remove any parts that are corroded from the battery. Then, reconnect the positive and negative pole cables.

Water Damage

If your 208 won't turn on and the battery is not flat then you should check that the spark plugs are working. You may find that they are simply too filthy and don't spark. The spark plugs can be cleaned in an workshop.

Peugeot cars use a transponder key that works with the car's ignition system. This ensures that only the correct key can turn the engine. If the chip inside the Peugeot key is damaged, it will not send the correct signal to the vehicle.

This is a common problem that is caused by water damage. This is particularly common in colder climates, as the vehicle might have been exposed to snow or rain. In this instance, you should contact a reputable locksmith who will have the necessary tools and equipment to modify the key. They will also have the most up-to-date technological know-how and machinery required to make a Peugeot 208 smart key. The process shouldn't last more than 15 minutes.

Contacts with the battery may be damaged.


Peugeot replaced the old transponder chips using a new model that is based on electronic components mounted on a circuitboard. The new system is fantastic in its initial state, but the circuit boards deteriorate over time and stop working properly.

This can prevent the immobiliser chip from working which means that your car won't start. If this happens, it's recommended to seek out a Peugeot specialist or locksmith.

A common issue occurs when the battery in the key fob starts to die. This causes the blade of the key to stop feeding into your lock. A locksmith in your car can replace the battery and cut a fresh blade for you, it's typically a quick fix.

Faulty Receiver Module

If your Peugeot key fob has stopped working after dropping it on the floor, or being exposed to a sudden downpour or accidentally washing it the wrong way, it could be due to a malfunctioning receiver module. The receiver is responsible for sending radio frequency signals to the onboard computer, which is responsible for controlling the centralized locking system in your Peugeot vehicle.

The key fob itself has rubber seals which prevent water from getting to the electronic chip inside. The chip can be damaged by water when exposed to the water for an extended period of time. Submerging the key fob in ocean water on the beach or throwing it into the water can be particularly damaging due to the high salt content.

If your Peugeot spare key fob stops working then you'll have to get the module replaced. This is only done by an expert auto locksmith or Peugeot specialist. Peugeot keys unlike other automobiles, are secured by an immobilizer system. This requires the proper codes to start the car. This is the reason that you should only trust the Peugeot locksmith to design and program a replacement.

Computer on board is not working properly

The on-board computer in your Peugeot is responsible for a variety of the systems inside the car, from power windows to the airbags. The on-board computer displays the code when something goes wrong. This code is saved in the system and stays there until the issue is solved. This could mean that the on-board computers to be replaced.

The most common cause of the warning light for airbags to come on is corroded or loose connections within the sensor. This can be caused by wear and tear, aging, exposure to salt and moisture. It is essential to have this issue addressed as quickly as you can, since an airbag that is malfunctioning can be risky in the event of an accident.

If your Peugeot is showing a card that is not being detected error, then the battery inside the key fob might be dead or weak. peugeot car key could prevent the key fob from sending a signal that disarms the standard immobilizer in your vehicle. Test this by pressing the unlock button on the fob's key, then trying to start your vehicle. If it doesn't work then the battery in the key fob must be replaced.

Homepage: https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/