Notes

The Reasons Peugeot Keys Is More Difficult Than You Think
Peugeot 208 Key Replacement

It is better to leave the replacement of Peugeot keys 208 to auto locksmiths with the right equipment and know-how. They can create and program new keys much quicker than a dealership and at a lower cost.

A dead battery for your coin is the most likely cause when your key fob stops locking or unlocking doors. There are other reasons for the key to be malfunctioning.

Dead Coin Battery


A dead coin battery can hinder your Peugeot 208 from locking or unlocking and will not start the engine. In this instance you'll need to use the alternative starting method found in your vehicle's owner's manual.

The spark plugs could also be worn out. Spark plugs are what ignite the fuel to start the engine. However, they have a limited life span. If they're not used enough and they fail, they'll eventually die.

Luckily, there's an easy solution to this problem. Check peugeot spare key cost of the battery using a multimeter. If it's less than 11.5 Volts then you must replace it. It is also important to clean the battery's contacts in the event that it is damaged by corrosion. You can do this by lifting the rubber covers that cover the two battery terminals and using wire brushes to clean any corroded areas of the battery. It is then time to reconnect the cables that connect the positive and negative poles.

Water Damage

If your 208 isn't starting and the battery isn't flat, then you need to make sure that the spark plugs work. It could be that they are just overly dirty, which causes them not to spark. The spark plugs can be cleaned in the workshop.

Peugeot automobiles use transponder keys that is compatible with the car's immobiliser system. This guarantees that only the right key is able to turn the engine. If the chip inside the Peugeot key is damaged, it won't send the proper signal to the vehicle.

Water damage is a common reason for this issue. This is most common in colder climates where the vehicle might have been exposed to snow or rain. If this is the case, you should contact a reputable auto locksmith who will have all the tools and equipment required to reprogram the new key. They will also have the latest technology and the machinery needed to create a Peugeot 208 smart key. The process shouldn't take more than 15 minutes.

Faulty battery contacts

Peugeot replaced the transponder chips by introducing a new type that uses electronic components mounted on a circuit board. The new system works great in its initial state, but the circuit boards wear out over time and stop working properly.

This can stop the immobiliser chip from triggering, so your car won't start. If this happens it's a good idea to call a Peugeot specialist or locksmith.

A common issue is when the battery of the key fob begins to fail. This causes the blade of the key to stop feeding into the lock. A locksmith for cars can replace the battery and cut a fresh blade for you, this is typically a quick fix.

Faulty Receiver Module

If your Peugeot key fob was not working after dropping it on the floor, being exposed to a sudden rain or accidentally washing it or washing it, it could be due to a defective receiver module. The receiver module is responsible for transmitting radio frequencies to the onboard computer which controls the central locking system of your Peugeot vehicle.

The key fob itself has rubber seals which prevent water from getting to the electronic chip inside. The chip can be damaged by water when it is exposed to water for long periods of time. Submerging the key fob into ocean water on the beach or throwing it into the water can be especially damaging because of the high salt content.

If your Peugeot spare key fob stops working then you'll have to get the module replaced. This can only be done by an Peugeot specialist or an expert auto locksmith. Peugeot keys, unlike other cars, are protected by an immobilizer system. This requires the proper programming to allow the car to start. It is for this reason that you should only rely on an authorized Peugeot locksmith to create and program an alternative.

Computer on board is not working properly

The on-board computer of your Peugeot is responsible for various systems inside your car, including airbags and power windows. When something goes wrong with these systems, they will usually display a code that identifies the problem. The code is stored within the system and remains there until the problem has been resolved. Often, this will involve the on-board computer being replaced.

The most common cause of the warning light of the airbag to flash is corrosion or loose connections within the sensor. This can occur due to wear and tear, aging, or exposure to salt and moisture. It is imperative to have this issue addressed as soon as you can, as the airbag malfunctioning could be risky in the event of an accident.

If your Peugeot is showing a card detected as not present error, then the battery in the key fob could be dead or weak. This prevents the key fob from sending a signal that disables the standard immobilizer in your vehicle. Test this by pressing the unlock button on the fob's key and then trying to start your car. If this doesn't work then the battery in the key will need replacing.

Read More: https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/