Notes

10 Peugeot Keys Tricks All Experts Recommend
Peugeot 208 Key Replacement

Peugeot 208 key replacement should be left to experienced auto locksmiths with the right equipment and technical know-how. They can create and program new keys much faster than a dealership would and at a lower cost.


A dead battery for your coin is the most likely cause the reason why your key fob isn't locking or unlocking the doors. There are other reasons that the key could be malfunctioning.

Dead Coin Battery

A dead battery in the coin compartment will stop your Peugeot 208 from locking or unlocking, and cannot start the engine. In this situation you'll need to use the alternative starting method found in your vehicle's owner's manual.

The spark plugs may also be worn out. The spark plugs are responsible for sparking the fuel that ignites the engine. They are only able to last for a short time. If they're not used enough and they fail, they'll eventually die.

Luckily, there is an easy solution for this problem. Check the voltage of your battery using a multimeter. If the voltage is lower than 11,5 volts, it's the time to replace it. If the battery is corroded, it is important to clean its contacts. This can be done by taking off the rubber covers from the two terminals on the battery and then using a wirebrush, you can remove any damaged parts of the battery. Then, you should reconnect the positive and negative pole cables.

peugeot replacement key fob

If your 208 isn't starting and the battery is not empty, you must ensure that the spark plugs are functioning. You may find that they're dirty and don't spark. This can be fixed easily by cleaning the spark plugs in the workshop.

Peugeot automobiles are equipped with a transponder compatible with the immobiliser. This ensures only the correct key can turn the engine. If the chip in the Peugeot key is damaged, it won't send the correct signal to the vehicle.

This is a frequent issue that is caused by water damage. This is especially prevalent in colder climates, where the vehicle could have been exposed to snow or rain. If this is the case, call a reputable auto locksmith who will have all of the tools and equipment needed to reprogram the new key. They also have the most up-to-date technological know-how and the equipment required to create the Peugeot 208 smart key. The process shouldn't take more than 15 minutes.

Contacts with the battery may be damaged.

Peugeot changed from the carbon-encased transponder chips to a new type of chip that relies on electronic components within a circuit board. The new system is effective when it's fresh, but as time passes, the circuit boards begin to wear out and stop functioning properly.

This can stop the immobiliser from triggering so that your vehicle won't be able to start. Contact an Peugeot specialist, or a locksmith, if this is the situation.

A common issue is when the battery of the key fob begins to die. This causes the blade of the key to stop feeding into your lock. A locksmith from your vehicle can replace the battery and cut a new blade for you, this is normally a quick fix.

Faulty Receiver Module

It could be that the receiver module is faulty when your Peugeot key fob stops working after being dropped on the floor, exposed to a sudden storm or accidentally washed. The receiver is responsible for transmitting radio frequency signals to the onboard computer, which is responsible for controlling the centralized locking system inside your Peugeot vehicle.

The key fob itself is fitted with rubber seals which prevent water from reaching the chip inside. Water can damage the chip when exposed to water for a long period of. Submerging the key fob in sea water at the beach or throwing it into the pool could be especially damaging because of the high salt content.

If your Peugeot spare key fob isn't working it is necessary to have the module replaced. This can only by done by a Peugeot specialist or an expert auto locksmith. As opposed to other cars, Peugeot keys are protected by an immobilizer that is unique and requires the correct programming in order to start the engine. This is the reason that you should only rely on the Peugeot locksmith to create and program the replacement.

Computer with a problem on board

The computer on the board of your Peugeot is responsible for many of the systems in your vehicle, from airbags to power windows. If something goes wrong with these systems, it will usually show a code that identifies the issue. The code is stored within the system and will stay there until the problem is fixed. In most cases, this will require replacing the onboard computer.

One of the main causes of the airbag light flashing is loose or corroded connections within the airbag sensor. This could be due to wear and tear, aging, exposure to salt and moisture. It is imperative to have this issue addressed as quickly as you can, since an airbag that is not functioning properly could be risky in the event of an accident.

If you notice an error message stating that the card is not found on your Peugeot, the key battery inside the key fob may be weak or dead. This can prevent the key fob from sending a signal that disables your vehicle's immobilizer. Test this by pressing the unlock key on the key fob and then trying to start your vehicle. If this fails then the battery in the key will need replacing.

My Website: https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/