Notes

The Reason Behind Peugeot Keys Is Everyone's Obsession In 2023
Peugeot 208 Key Replacement

It is recommended to leave the replacement of Peugeot 208 keys to auto locksmiths who have the required equipment and know-how. They can program and create keys faster and cheaper than dealerships.

A dead coin battery is most likely to blame when your key fob stops locking or unlocking the doors. There are other reasons for the key to be malfunctioning.

Dead Coin Battery

A dead battery in the coin compartment will hinder your Peugeot 208 from locking or unlocking and will not start the engine. In this situation you'll need employ the alternate method of starting found in your vehicle's owner's manual.

Another reason the 208 won't start is because the spark plugs have been damaged. The spark plugs are responsible for igniting the fuel that powers the engine. However they are limited in their time of life. They will eventually break down if they aren't used frequently enough.

Luckily, there's an easy solution for this problem. Check the voltage of your battery using a multimeter. If peugeot 206 key replacement G28CarKeys than 11.5 volts then you must replace it. If the battery is corroded, it is important to clean its contacts. This can be done by lifting the rubber covers that protect the two terminals of the battery and using a wire brush to remove any corroded components of the battery. Then, you should connect the cables for the positive and negative poles.

Water Damage

If your 208 doesn't start and the battery isn't flat then you should check whether the spark plugs are working. It could be that they are simply too dirty and they don't spark. The spark plugs can be cleaned in an workshop.

Peugeot automobiles use a transponder style key that works with the car's ignition system. This ensures only the correct key is able to turn the engine. If the chip inside the Peugeot key is damaged, then it won't send the proper signal to the vehicle.

Water damage is a common cause of this issue. This is especially prevalent in colder climates. the vehicle may have been exposed to rain or snow. If this is the case, contact a reputable auto locksmith who will have all the equipment and tools needed to change the key's programming. They will also have all the latest technology and equipment needed to create the Peugeot smart key. The process shouldn't last more than 15 minutes.

Contacts to the battery are not working properly.

Peugeot replaced the old transponder chips with a brand new model that utilizes electronic components that are mounted on a circuitboard. The new system works great when it's new, however the circuit boards wear out over time and cease to function properly.

This could stop the immobiliser from triggering so that your vehicle won't start. If this is the case it's best to seek out a Peugeot specialist or locksmith.

Another issue that is common is when the key fob battery begins to fail, which causes the key blade to stop getting into the lock. A car locksmith can replace the battery and cut a fresh blade for you, it's normally a quick fix.

Faulty Receiver Module

If your Peugeot key fob stopped working after dropping it on the ground, being exposed to a sudden downpour or accidentally washing it the wrong way, it could be due to a faulty receiver module. The receiver is responsible for transmitting radio frequency signals to the on-board computer, which controls the central locking system in your Peugeot vehicle.


Rubber seals on the key fob stop water from getting to the electronic chip. Water can damage the chip when it is exposed to water for a prolonged period of time. Submerging the key fob into ocean water on the beach or throwing it into the pool can be especially damaging because of the high salt content.

The module will need to be replaced if the Peugeot spare key is no longer working. This can only by done by an Peugeot specialist or a professional auto locksmith. Peugeot keys like other cars are secured by an immobilizer device. This requires the proper codes to start the car. This is why you should be able to trust a professional Peugeot locksmith to handle the task of designing and programming an alternative.

Faulty on-Board computer

The on-board computer in your Peugeot is responsible for many of the systems in your car, including airbags and power windows. The on-board computer will show a code if something goes wrong. The code is stored within the system until the issue is fixed. This may require the on-board computers to be replaced.

The most frequent cause for the airbag warning light to come on is corroded or loose connections within the sensor. It can be due to wear and tear, ageing or exposure to moisture and salt. It is imperative to have this issue addressed as quickly as possible, since a malfunctioning airbag can be dangerous in the event an accident.

If you find an error message stating that the card is not found on your Peugeot key fob, the battery in the key fob may be dead or weak. This can prevent the key fob from transmitting a signal that will disable the standard immobilizer in your vehicle. Test this by pressing the unlock key on the key fob, and then trying to start your vehicle. If this fails it is because the battery of the key needs to be replaced.

Website: https://www.g28carkeys.co.uk/peugeot-car-key-replacements-near-me/