Notes

The No. 1 Question Everyone Working In Subaru Forester Key Replacement Must Know How To Answer
Subaru Impreza Key Problems

Subaru Impreza keys enable owners to lock or unlock their vehicle by pressing the button. The most common reason for the key fob to stop working is a dead coin battery in the key fob.

It is easy to change the battery. Find the small device that contains the flat round cell inside the casing of the key. Open it and replace the battery, ensuring that the correct side is facing forward.

Lost or Stolen Keys

We've all been there when you reach into your pocket to grab your keys only to find them nowhere to be found. Luckily, it's rarely difficult to locate your Subaru keys, and there are several ways to get them replaced quickly and inexpensively.

If you already have a standard metal car key, you can have it duplicated at a hardware store that has Subaru blanks. They are typically marked "Subaru". You may need to replace the battery of your key fob too in which case you'll require a CR-2032 replacement that can be found at many hardware stores and a few retailers like Amazon.

For the key fob or remote/intelligent key, you'll need go to an automotive locksmith who can create new keys for your Subaru model. You'll pay between $50-$250, based on if your Subaru features a transponder or smart key.

You'll have to provide the locksmith or dealer with your vehicle identification number (VIN) found on the dashboard, just below the windshield. This number is required to verify the warranty status of your car and ensure that the key has been properly programmed for your Subaru model and year. The VIN also contains information about the manufacturer, where the car was manufactured, and whether it comes with any particular features, such as an immobilizer, that prevent the engine from running if the wrong key is used.

Key fob not working properly

A key fob that doesn't work properly can be the result of a variety of factors. It could be as simple as a battery problem or a more intricate repair. Some common issues with the Subaru key fob is batteries that have died and programming issues with the car, and other electrical issues with the vehicle.

The battery on the key fob can be replaced easily. These can be found at some big-box retailers and hardware stores. They are priced at around $10 and can be replaced in a couple of minutes. The owner's manual should have instructions on how to do this. There are numerous YouTube videos that can walk you through the procedure.

Another possible cause is water damage to the key fob. The clips made of metal that keep the batteries in place could be damaged if remove it from your pocket and get it wet. If the key fob still isn't working after replacing the batteries, the issue could be related to the transmitter or other components of the vehicle. A technician trained in troubleshooting vehicles can check this and find the problem. They can reprogramme your key fob to ensure that it is compatible with your vehicle. They can also check for antenna or wiring issues that could prevent the key fob from transmitting signals correctly.

Unlocking or Locking Issues

There are a few possibilities for the Subaru Impreza's key fob not locking or unlocking the doors. A dead coin battery in the key fob or a malfunctioning receiver module and signal interference, water damage or a paired key that needs reprogramming are all possible causes of this problem. To fix this, you can go to an expert locksmith or dealer to have the key fob reprogrammed.

If you're not able to access the trunk, it is likely that the setting of the trunk lock on the key fob is set to "on". This is a safety feature that stops thieves from stealing your vehicle. Contact your SUBARU dealership to alter the settings for the trunk lock and unlock.


A locked steering wheel can also occur when the vehicle locks automatically following a sharp turn. This happens when the car senses a rapid turn, which could impact its transmission system and engine. Make sure to slow down when turning to avoid this.

Make sure you check that the replacement keys or the spare key that you have was cut and programmed by the locksmith or dealer. Make sure that the emergency key can work on the trunk and all door cylinders as it is the only means to gain access back into your vehicle in the event that you are locked out. Check that the spare key or the new key doesn't have any scratches or signs on it.

Keyless Entry

Many Subaru models are equipped with keyless entry. This allows you to lock or unlock the doors and trunk by pressing a button on the remote. The system is based on an extremely short radio signal that communicates with the vehicle when you're within its range. There are a variety of different systems on the market that can provide this function starting with the basic ones that allow you to unlock only the door for the driver to more advanced models that allow remote starting and smartphone integration.

It's convenient and secure to have keyless entry into your Subaru, but you should know what to do in the event that the buttons stop functioning. Try troubleshooting yourself, but it could be essential to have your Subaru examined by a professional. In the meantime, you can use these tips to keep your car's remote functioning as intended.

If subaru locked keys in car that controls the key on your Subaru gets wet the fob should be cleaned with isopropyl and allow it to completely dry before installing the battery. This will keep moisture from causing damage to the fob, and causing other issues later on.

If your key fob isn't responding, turn off the engine and open the door of the driver. Press the button for the door to unlock, then close it, pressing the button a particular number of times (usually one for each digit) until you hear a chime. Then, repeat the process with each door until receive a response from each of them.

Read More: https://www.g28carkeys.co.uk/subaru-car-key-replacements-near-me/