Notes

Dexterity in between expansion and also anxiety reactions through DELLA inside the liverwort Marchantia polymorpha.
The occurrence of the Maillard reaction and melanoidins formation during the hydrothermal treatment of food waste can reduce the yield of volatile fatty acids (VFA); however, few studies have investigated the adverse effects of the Maillard reaction. This study identified the impact of hydrothermal treatment parameters on hydrolysis and melanoidins formation and optimized the hydrothermal treatment conditions to enhance VFA production by minimizing the impact of the Maillard reaction. A response surface methodology was employed to optimize the hydrothermal treatment parameters and VFA production was evaluated. Results showed that temperature, reaction time, and pH were significant interacting factors with respect to hydrolysis and melanoidins formation while the C/N ratio and moisture content of food waste had little impact. The optimal conditions for hydrothermal treatment (temperature of 132 °C, reaction time of 27 min, and a pH of 5.6) enhanced VFA production by 22.1%. Under optimal hydrothermal treatment conditions, a higher initial C/N ratio further increased VFA production.Selenium nanoparticles (Se NPs) are less toxic and more biocompatible than selenite or selenate. However, studies involving spraying with Se NPs for reducing accumulation of cadmium (Cd) and lead (Pb) in rice grains have been rarely reported as yet. Herein, indica rice seedlings cultivated in Cd+Pb-spiked paddy soils (denoted as positive control) were sprayed with Se NPs sols for four times from tillering to booting stage. Compared to positive control, 50-100 μmol/L Se NPs downregulated Cd transporters-related genes such as OsLCT1, OsHMA2 and OsCCX2 in leaves and OsLCT1, OsPCR1 and OsCCX2 genes in node I at filling stage. Meanwhile, Se-binding protein 1 was distinctly elevated, involving the repression of Cd and Pb transportation to rice grains. Se NPs also differentially improved RuBP carboxylase and chlorophylls especially some key genes and proteins involving photosynthetic system. Besides, 25-50 μmol/L Se NPs diminished reactive oxygen species overproduction from NADPH oxidases whereas boosted glutathione peroxidase, reducing protein carbonylation in rice seedlings. However, the antioxidant isozymes and oxidatively modified proteins were slightly rebounded at 100 μmol/L. Se contents were noticeably elevated and confirmed to exist as selenomethionine in the rice grains following all the treatments by Se NPs. Thus, the optimal dosage of Se NPs for foliar application is 50 μmol/L, which significantly decreased Cd accumulation, improved photosynthesis and Se enrichment whereas caused no distinct reduction of Pb in the grains. Thus, an appropriate dosage of Se NPs can be conducted to decrease Cd accumulation, improve photosynthesis, and organic Se contents in rice grains.More and more attention has been paid to the aggregation behavior of nanoparticles, but little research has been done on the effect of particle size. Therefore, this study systematically evaluated the aggregation behavior of nano-silica particles with diameter 130-480 nm at different initial particle concentration, pH, ionic strength, and ionic valence of electrolytes. The modified Smoluchowski theory failed to describe the aggregation kinetics for nano-silica particles with diameters less than 190 nm. Besides, ionic strength, cation species and pH all affected fast aggregation rate coefficients of 130 nm nanoparticles. Through incorporating structural hydration force into the modified Smoluchowski theory, it is found that the reason for all the anomalous aggregation behavior was the different structural hydration layer thickness of nanoparticles with various sizes. The thickness decreased with increasing of particle size, and remained basically unchanged for particles larger than 190 nm. Only when the distance at primary minimum was twice the thickness of structural hydration layer, the structural hydration force dominated, leading to the higher stability of nanoparticles. This study clearly clarified the unique aggregation mechanism of nanoparticles with smaller size, which provided reference for predicting transport and fate of nanoparticles and could help facilitate the evaluation of their environment risks.To study the pollution features and underlying mechanism of PM2.5 in Luoyang, a typical developing urban site in the central plain of China, 303 PM2.5 samples were collected from April 16 to December 29, 2015 to analyze the elements, water soluble inorganic ions, organic carbon and elemental carbon. The annual mean concentration of PM2.5 was 142.3 μg/m3, and 75% of the daily PM2.5 concentrations exceeded the 75 μg/m3. The secondary inorganic ions, organic matter and mineral dust were the most abundant species, accounting for 39.6%, 19.2% and 9.3% of the total mass concentration, respectively. But the major chemical components showed clear seasonal dependence. SO42- was most abundant specie in spring and summer, which related to intensive photochemical reaction under high O3 concentration. In contrast, the secondary organic carbon and ammonium while primary organic carbon and ammonium significantly contributed to haze formation in autumn and winter, respectively. This indicated that the collaboration effect of secondary inorganic aerosols and carbonaceous matters result in heavy haze in autumn and winter. Six main sources were identified by positive matrix factorization model industrial emission, combustion sources, traffic emission, mineral dust, oil combustion and secondary sulfate, with the annual contribution of 24%, 20%, 24%, 4%, 5% and 23%, respectively. The potential source contribution function analysis pointed that the contribution of the local and short-range regional transportation had significant impact. This result highlighted that local primary carbonaceous and precursor of secondary carbonaceous mitigation would be key to reduce PM2.5 and O3 during heavy haze episodes in winter and autumn.Organic polymeric flocculants are commonly used in improving dredged sludge dewaterability, but less attention has been paid to residual water quality. In this paper, the effects of cationic etherified starch (CS) and poly-dimethyl diallyl ammonium chloride (PDDA) on dredged sludge dewatering efficiency and residual water quality of Baiyangdian lake were comprehensively investigated and evaluated by analytic hierarchy process (AHP). The results indicated that PDDA had stronger electrical effect and flocculation performance compared with CS, resulting in more efficient dewatering performance. PDDA can reduce the pollutants of discharged residual water, while CS significantly promoted the increase of NH4+-N and NO3--N in the residual water. The increase of NH4+-N in the residual water of CS was due to the release of dredged sludge, while the increase of NO3--N was introduced by CS leaching. AHP showed that PDDA performed better in flocculation treatment of dredged sludge than other organic polymers. This work provides a method for optimization of flocculation treatment for dredged sludge dewaterability.Light climate is of key importance for the growth, community composition of submerged macrophytes in lakes and, they, in turn, are affected by lake depth and the degree of eutrophication. To test the relationships between submerged macrophyte presence and the ratio of Secchi disk depth (SDD) to water depth, i.e. SDD/depth, nutrients and wind, we conducted an extensive sampling campaign in a macrophyte-dominated area of the eastern region (n = 36) in 2016 in Lake Taihu, China, and combined the data gathered with results from extensive physico-chemical monitoring data from the entire lake. We confirmed that SDD/Depth is the primary factor controlling the community composition of macrophytes and showed that plant abundance increased with increasing SDD/Depth ratio (p 0.05). click here The key to restore the macrophyte beds in the lake is to reduce the nutrient loading. A decrease of the water level may contribute as well in the shallow bays but will not bring plants back in the main part of the lake. As the tolerance of shade and nutrients varied among the species studied, this should be taken into account in the restoration of lakes by addition of plants.Widespread use of azole fungicides and low removal efficiency in wastewater treatment plants (WWTPs) have led to the elevated concentration of azole fungicides in receiving environment. However, there was limited research about the removal mechanism of azole fungicides in the biological treatment of WWTPs. Imidazole fungicide climbazole and triazole fungicide fluconazole were selected to investigate the biodegradation mechanism of azole fungicides in activated sludge under aerobic conditions. Climbazole was found to be adsorbed to solid sludge and resulted in quick biodegradation. The degradation of climbazole in the aerobic activated sludge system was fitted well by the first-order kinetic model with a half-life of 5.3 days, while fluconazole tended to stay in liquid and had only about 30% of loss within 77 days incubation. Ten biotransformation products of climbazole were identified by high resolution mass spectrometry using suspect and non-target screening method. But no biodegradation products of fluconazole were identified due to its limited removal. The possible biodegradation pathways for climbazole were proposed based on the products identification and pathway prediction system, and involves oxidative dehalogenation, side chain oxidation and azole ring loss. The findings from this study suggest that it should be a concern for the persistence of fluconazole in the environment.Capturing flue gases often require multiple stages of scrubbing, increasing the capital and operating costs. So far, no attempt has been made to study the absorption characteristics of all the three gases (NO, SO2 and CO2) in a single stage absorption unit at alkaline pH conditions. We have attempted to capture all the three gases with a single wet scrubbing column. The absorption of all three gases with sodium carbonate solution promoted with oxidizers was investigated in a tall absorption column. The absorbance was found to be 100% for CO2, 30% for NO and 95% for SO2 respectively. The capture efficiency of sodium carbonate solution was increased by 40% for CO2 loading, with the addition of oxidizer. Absorption kinetics and reaction pathways of all the three gases were discussed individually in detail.In this work, the waste biomass lotus leaf was converted into N-doped porous carbonaceous CO2 adsorbents. The synthesis process includes carbonization of lotus leaf, melamine post-treatment and KOH activation. For the resultant sorbents, high nitrogen content can be contained due to the melamine modification and advanced porous structure were formed by KOH etching. These samples were carefully characterized by different techniques and their CO2 adsorption properties were investigated in detail. These sorbents hold good CO2 adsorption abilities, up to 3.87 and 5.89 mmol/g at 25 and 0°C under 1 bar, respectively. By thorough investigation, the combined interplay of N content and narrow microporous volume was found to be responsible for the CO2 uptake for this series of sorbents. Together with the high CO2 adsorption abilities, these carbons also display excellent reversibility, high CO2/N2 selectivity, applicable heat of adsorption, fast CO2 adsorption kinetics and good dynamic CO2 adsorption capacity. This study reveals a universal method of obtaining N-doped porous carbonaceous sorbents from leaves.
My Website: https://www.selleckchem.com/products/Bleomycin-sulfate.html