Notes

What Experts Say You Should Be Able To
How to Replace a Kia Sportage Replacement Key

The key in many Kia models has an entry system that is keyless into. The key can be compared to the remote control and is able to be replaced with a brand new one from a Kia dealer or a locksmith.

Key fobs may stop working due to a variety of reasons, such as batteries that are dead, worn-out buttons signal interference or water damage. Here are some helpful tips on how you can get your Kia Sportage replacement key to function again.

How to replace the remote key or the smart key?

No matter if your Kia is equipped with an intelligent key, remote key push to start key or a standard non-transponder key made of metal The battery inside these keys will eventually require replacement. This is especially the case if your car shows a message that states the remote or smart keys are not powered by batteries.

It's a simple procedure. To replace the battery on the keyfob remove your mechanical key from the slot at the back of the fob. Then, pry the cover off. Inside the key fob, there will be tiny screws that hold the battery in place. Using a small screwdriver, loosen the screw and remove the old battery. Install the new battery and close the slit on the key fob.

Test the key fob by pressing the lock/unlock buttons. If linked web site unlock and lock exactly as you expect, then you're set! You can now use the hands-free feature to lock and unlock your Kia whenever your fingers feel cold or when you need to complete errands in Brandon.

Note: Some key fobs (transponder chip or smart keys) might require their programming done. This requires a specific programming machine that only the dealer or automotive locksmith has access to. Other keys (non transponder keys made of steel), do not need programming. If you need to reprogramme your key, you'll need to note the key code's number on the tag for the key code.

How do you replace a battery?

If your Kia key fob is not responding when you press the lock or unlock button on the fob, this is a sign that the battery should be replaced. A low battery can also cause other issues, such as the check engine light flashing or the engine not cranking properly. Fortunately replacing the key fob battery is a simple DIY task that requires only a few tools.

Be sure to turn off your vehicle and close all doors before you begin. Locate the small plastic piece that is on the bottom of your key fob and move it until a metal key slides out. The key can be put into the door's driver handle to unlock your car.

To replace the key fob's battery, take off the cover from the back and use a plier bar tool to release the latch that holds the black negative battery cable. Remove the old battery and then align the replacement battery so that its "+" side is facing you, and the "-" negative side is facing the fob's electrical contacts. Push the new CR2032 battery straight into place with care to avoid using too much force to avoid damaging or bending the contacts made of metal.

Once the new battery is installed then turn the key fob off and then turn it on in the ignition repeatedly until the door locks cycle. You can then test the Kia's Key fob to ensure it's functioning properly.

How do I replace a smart key

You may have either the standard keyfob or Smart Key, based on the model of Kia Sportage. The difference between the two is that the smart key has an incredibly small key blade that is hidden inside, while the standard fob isn't equipped with. Both types of key fobs have batteries that eventually will need to be replaced. This is a simple procedure that takes less than two minutes.


Be sure to turn off your Kia, and be on a level, well-lit surface before you begin. Be aware that there are tiny pieces inside the fob that can be removed if not careful.

The release button for the small size is located on the lower backside. It could be an oval or circular slot. You can open the key fob by pressing the button.

After the key fob has been removed, you can remove the battery that was in it. The new battery is one called CR-2032 and can be purchased on the internet or at your local auto parts shop. Once you're done you should be able to lock or unlock your car with your key fob even if the engine isn't running!

How do I replace the mechanical key?

The Kia key fob is a great convenience that allows us to lock and unlock our car at the press of one button. But like any device, it can have problems occasionally. There are solutions to address these issues and keep your key fobs in good working order for an extended period of time.

A dead or drained battery is one of the most frequent problems. This could cause your device to stop working or work intermittently. If this happens try replacing the battery with a new one.

If this doesn't resolve the issue, try using a standard flathead screwdriver to wedge open the casing of the fob's plastic. Be careful not to damage any internal components, or scratch the plastic. After opening, carefully remove the old battery and replace it with a brand new one.

Close and open the door with the mechanical key. (Every kia fob comes with an emergency mechanical key which will fit into the slot). Test the key fob to ensure it's functioning correctly. Contact a dealer locksmith to resolve the problem in the event that the key fob is not working. To avoid locking outs in the future, ensure that you have an emergency key that will work on all trunk and door cylinders.

Read More: https://www.thekeylab.co.uk/kia-car-keys/