Notes

One Fiat 500 Replacement Key Cost Success Story You'll Never Believe
Fiat 500 Replacement Key Fob

It's possible to change the battery if the 500 remote key fob isn't working. If you replace the battery and it's still not working, the problem may be elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have the tools and spare parts needed for this job.

Dead Coin Battery

The most common reason your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob is equipped with an internal battery called a coin cell that can quickly deplete when it isn't being frequented enough. If your remote began to show signs of weakness such as a loss of range and then completely stopped working the battery could be dead.

G28 inside the key fob is held in place by steel clips for retaining. If the clips aren't tightly secured, they could result in contact issues that prevent your remote from receiving power. Using a small flathead screwdriver, pry the retaining clip open to remove the battery and insert a new one. Make sure to select an alternative battery that has the same type of voltage, size, and specification as the original battery.

The key fob can also be damaged or corroded by water exposure. Even a quick bath in soapy, warm water can damage the chip. Make sure your key fob is dry.


Water Damage

Water damage could be the reason behind your key fob's inability to function properly. Key fobs have rubber seals that stop them from being damaged by rain or a splash of water. However, it is essential to keep your keys safe from the ocean, pool, and the washing machine!

The key fob comes with an electronic chip that transmits an electronic message to the immobilizer system of your vehicle. The chip allows the 500 to start and lock. If it gets wet it will not work.

You can clean the internal electronics of your key fob with isopropyl Alcohol or an electronic cleaner to see whether they're still functioning. However, it's better to purchase a replacement from a dealer rather than trying to repair an item that is submerged in salt water.

While a replacement fob can cost a little money, it is a lot cheaper than paying for your Fiat 500 to be towed to the dealer and repaired! You can also fix it yourself by following only a few steps. Make sure you have the correct type of battery prior to opening your keyfob. This is a job that's much simpler than it appears and you can find step-by-step instructions on the internet for nearly any key fob in your car.

Faulty Chip

The chip in the key fob communicates with the immobiliser on your vehicle to ensure that the vehicle will start only when the right keys are in place. If the chip is damaged or destroyed the car will not start regardless of what you do.

Damage to the water or a dead phone battery are the most common causes of defective chips. Whatever the reason, it's best to delegate this task to a locksmith as they will be able to replace the chip for you quickly and at an affordable price.

If your key fob stops working after exposure to clean tap water or rain, take out the battery and wipe down the electronic component using a paper towel to ensure it is fully dry before putting it back into. If the key fob will not function, there is the possibility that it's damaged components and requires to be replaced.

A few people will visit their dealer if they need a new Fiat fob. However, this can be costly. If you're seeking a cost-effective solution to have your Fiat key fob repaired Look no further than United Locksmith. We have all the tools and expertise to repair your Fiat fob in a professional and timely manner.

Faulty Receiver Module

Fiat key fobs send signals up 50 feet to the vehicle, which can unlock and close the doors (and start the vehicle in case of automatic transmissions). There are many reasons why a fob could not function. These include a dead coin battery or water damage buttons, worn ones or a problem with the receiver module and signal interference or an electronic chip that is malfunctioning.

If the fob was in the pocket that has been subject to severe trauma (such as being dropped on the floor, or washed in the washing machine), it may not be in a position to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security device that only accepts signals from genuine original keys.

You will need to replace the fob in case this occurs. A professional locksmith can handle the entire replacement process including programming a new key for your 500. They can even provide an identical fob that functions just like the original (and costs a fraction of the price).

Homepage: https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/