Notes

20 Best Tweets Of All Time Fiat 500 Replacement Key Cost
Fiat 500 Replacement Key Fob

It could be time to replace the battery if your 500 remote key fob isn't working. If you replace the battery, but it still doesn't work, the problem may be elsewhere.

United Locksmith specializes in the production of new keys for classic vehicles. We have the tools as well as the parts required for this type of service.

Dead Coin Battery

The most common reason your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The key fob contains a coin cell battery that can quickly deplete when it isn't frequently used. If your remote starts to show signs of loss of range, or has stopped working or not responding, then the battery could be dead.

The battery inside the key fob is secured by metal clips that hold it in place. If the clips are not tightly secured, they could result in contact problems that will prevent your remote from receiving power. Use a flathead screwdriver break open the retaining clip and remove the battery. Make sure to use a battery with the same size, voltage and specification as the original.

Water exposure can also cause the key fob to corrode or be damaged. Even a brief bath in soapy water could harm the electronic chip within. Make sure your key fob is dry.

Water Damage

If your key fob isn't working properly, it may be caused by water damage. G28 Car Keys come with rubber seals that stop them from being damaged by a light rain or splashes of water, but it is vital to keep your keys away from the pool, ocean and washing machine!

The key fob comes with an electronic chip that transmits a signal car's immobilizer system. The chip is what allows the 500 to lock and start. If it gets wet it will not function.

Try cleaning your key fob's internal electronics with isopropyl alcohol or an electronic cleaner to determine if they are still good. It is best to replace a key fob in the event that it's submerged into salt water rather than attempting to repair it yourself.


While a replacement fob could cost you a little bit of money, it's a lot cheaper than having to pay for your Fiat 500 to be towed to the dealership and repaired! You could also do it yourself by following only a few steps. Make sure you have the correct battery type prior to opening your keyfob. You can find step-by-step instructions for every car keyfob online.

Faulty Chip

The chip that is contained in the key fob communicates to your car's immobiliser unit to make sure the car is able to start when the correct key is inserted. If the chip is damaged or damaged in any way, your car will not start.

Damage to the water or a dead phone battery are the most common causes of the chip being damaged. It is recommended to leave the task to a professional locksmith, who will be able to replace the chip quickly and at an affordable cost.

If your key fob does not work after being exposed to clean rain or tap water take the battery off. Wipe down the electronic component using paper towels. If the key fob will not work, there is an opportunity that it is damaged components and requires to be replaced.

A few people turn to their dealer when in need of a new Fiat key fob, however this could be a costly alternative. United Locksmith is the best choice if you are looking to have your Fiat keyfob fixed at a reasonable price. We have all the tools and knowledge required to fix your Fiat fob in a professional and timely manner.

Faulty Receiver Module

Fiat key fobs send signals up 50 feet to the vehicle, which allows it to unlock and close the doors (and start the vehicle for vehicles with automatic transmissions). However, there are a few factors that could cause the fob to cease functioning. This includes a dead coin-battery, water damage, worn out buttons as well as a receiver issue. signal interference or an issue with the chip.

If the fob was stored in a place that has endured extreme trauma, such as being dropped on hard floors or getting washed in a washer the fob may not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept signals from a genuine key and not another.

You'll have to replace the fob in case this occurs. A professional locksmith will manage the entire process of replacing keys including programming a new key to your 500. They can even provide a clone fob that works exactly the same way as the original (and costs only less than what it would cost).

My Website: https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/