Notes

The 10 Scariest Things About Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a little old but it's still eye-catching. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is persistent or intermittent these tips will assist.

Water Damage

If you accidentally drop your key fob in the puddle, or it gets wet while kayaking canoeing, rafting, or canyoning the fob is most likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry container when you're going outdoors or doing activities in which the fob may be exposed to excessive amounts of water.

It's also important to make sure that the fob is completely dried out before you open it to use it again. If you detect any smells coming from the fob, like an industrial smell or a sour taste like windshield washer fluid, it's another sign that it's been submerged in water.

A circuit board that's damp can cause the battery's charge to drop its charge, or even explode. If you can pull the 308 keyfob from the water and turn it upside up and shake as much water out as possible before opening the casing. After opening it, take out the battery and wipe down the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module malfunction, signal interference or a damaged chip. If none of these are the problem it is possible to reset the system by disconnecting a 12 volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start systems which allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely beneficial, especially in the cold winter months. However, it is possible that the remote stop system stops functioning due to a variety of causes, such as the battery in the coin is dead.

A coin-shaped battery found inside the key fob will last a time of two to four years, based on how often it's utilized and where it was purchased. The use-by date will be written on the packaging or mentioned in the user manual.

If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, then clean the chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If you expose it to salty or soapy water, the chip might be damaged and you'll have to replace the key fob altogether.

If you're not certain that the battery is not working properly you can check its voltage with a multimeter that is set to the car's voltage range. Connect it to the plus and minus terminals. The voltage should be around 12 to 13 volts, but if it is lower, the battery should be replaced. You can also try to reset your on-board computer by disconnecting the battery at 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should start.


Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has developed a fault. It is the part which sends out an alert when your key fob is activated. It also functions as an alarm that stops the vehicle from starting without the correct key.

This could be due to a range of causes including water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was contaminated with it. In this case you will have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once peugeot partner key replacement , you can put the battery back in and try again.

If the problem persists it is recommended to visit an area Peugeot expert or locksmith. They'll employ a diagnostic tool help pinpoint the issue and repair it for you.

It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can solve the problem in minutes. They can program your vehicle and cut a new, working key for you. Click here to find a locksmith near you.

A malfunctioning electronic chip

The electronic chip that is in your Peugeot 308 key fob is a very important part of the remote control system. If the chip is damaged, you could be unable to start your car or get a message saying "anti-theft". In this instance the only option is to replace the key. Luckily, auto locksmiths who are professionals can provide the service in the shortest amount of time.

The chip inside the chip of your Peugeot 308 key fob can become faulty due to sweat, water damage, dirt or other reasons. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned promptly. You can clean the electronic component with a paper towel soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.

Radio interference can cause a key fob's functionality to cease. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects around the vehicle. It is recommended to see a Peugeot dealer if you have this problem.

The Peugeot key fob 207/308 is extremely delicate and requires extra care. It is imperative not to drop or throw the key fob. If you lose it, try to find it as soon as you can. You can reset all on-board computers by disconnecting the battery that is 12 volts for a few minutes. Remove the negative cable before the positive.

Website: https://www.thekeylab.co.uk/peugeot-car-keys/