Notes

The Top Reasons People Succeed On The Nissan Qashqai Key Fob Industry
Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV feel due to its bigger dimensions, and the ride on 19-inch wheels in Ti and ST-L models may be firm at times. The front tyres could lose grip on rough surfaces and its CVT might occasionally exhibit wrist-flexing torque steer.

This is typically caused by an unresponsive coin battery that can be easily replaced in a matter of minutes. Make sure the replacement battery has the same voltage, size and specifications.

Water Damage

One of the main reasons a Nissan key fob might display the "key ID is incorrect" message is due to water damage. The rubber seals on the key fob are designed to protect the electronic chip, but long-term exposure to moisture can cause it not to work properly. It's common to see this when your key fob was dropped into the ocean or swimming pool. However, it can occur when it becomes wet from rain or soapy hands.

If your key fob is exposed to water for a long period of time, it might need to be cleaned using isopropyl alcohol, or electronic cleaner. It may also need to be sent to an expert to be repaired or replaced.


If your key fob require replacement the process is simple. First, ensure that you have a multipack with the correct battery (CR2032 3V). Then, you can open the back and front cases with the help of a small screwdriver. Remove the metal clips, remove the old battery and replace it. After reassembling your fob, put the mechanical key back into position and ensure that it is working correctly. If it doesn't then you'll have to go to your local Nissan dealer or a professional auto locksmith to repair the chip that controls the key. Fortunately, the chip is not normally damaged by exposure to water, so this should not cost you a lot.

Dead Coin Battery

The coin battery is a second common reason that your Nissan Qashqai remote key fob might not work. These batteries last for 3 to 5 years, but they may fail over time in the event that the fob has been frequently dropped. You can try replacing the battery with a fresh one but be sure it's the same voltage and size as the original. If you use a new battery, it could cause the key to be assigned an incorrect key ID. This could prevent it from being paired with your vehicle.

The best way to change the battery inside the Nissan Qashqai Key Fob is to open it with an small screwdriver that has a flat head. In the screwdriver, push it into a small notch on the bottom of the fob, and twist it gently to split the two halves of the key fob. Remove the old CR2025 battery and replace it with a new one, noting the position of the old one within the fob.

Before putting the new battery in place be sure that there isn't any dirt or water damage on the terminals. If not clean the terminals with some isopropyl ethanol. Make sure that the pole cables are properly connected. They must be connected to the positive and negative poles of your battery.

Diagnostics of a fault

If your Nissan Qashqai's key fob stops functioning after exposure to water that is clean from a tap or rain it could be a sign there is a problem with the internal chip. The battery replacement won't fix this, and you'll have to buy an entirely new key fob. If the key fob stopped working after dropping it, it's likely that the chip inside was damaged. You can usually get the key fob to work once again if it is removed and clean the chip using paper towel and isopropyl alcohol and then insert it back into.

A common error that you may notice on the dashboard of your vehicle is "Key ID Incorrect." The vehicle is unable recognize the key fob, and therefore will not allow the car to start. This can happen in numerous ways, including water damage, problems that are undetectable in the circuitry of the key fob or RFID interference.

The key fob will stop working if the 12 volt batteries are dead or do not provide sufficient electric current. This can affect the remote keyless system as well as central locking in your Nissan Qashqai, as well as hindering you from starting the engine using the key fob (if equipped with Intelligent Key). Check the batteries inside the key fob if you're not able to lock or unlock your door manually. Try re-inserting the battery to reset the transmitter.

Reprogramming

If replacement key for nissan qashqai has not been submerged in salt water and is unable to come back to life after a simple wash with clean water. You can also try cleaning the electronic chip with isopropyl alcohol or an electronic cleaner. If none of these works It could be the time to replace the entire key fob with an entirely new one.

If your Nissan Intelligent Key still does not function, there could be a connection issue between it and the vehicle. Start by turning the ignition switch without starting the vehicle. Continue this process until the hazard light flashes two times. Turn off your vehicle and remove the key.

Then, you need to open the fob compartment in your vehicle. It's usually located in the door jamb, on the handle on the driver's side or under the armrest. Find the small "program" button and press it. You should hear a chime when the process is completed.

It's time to put your Intelligent Key to the test. Make sure you press all the buttons on the key while standing a distance away from the car. If the lights flash and the horn sound this means that the key has successfully linked to the Nissan. You may also try testing the key in close proximity.

Website: https://www.thekeylab.co.uk/nissan-car-keys/