Notes

Interpersonal results about AVT and also CRF systems.
Aurivillius compounds with the general formula (Bi2O2)(An-1BnO3n+1) are a highly topical family of functional layered oxides currently under investigation for room-temperature multiferroism. A chemical design strategy is the incorporation of magnetically active BiMO3 units (M Fe3+, Mn3+, Co3+ …) into the pseudo-perovskite layer of known ferroelectrics like Bi4Ti3O12, introducing additional oxygen octahedra. Alternatively, one can try to directly substitute magnetic species for Ti4+ in the perovskite slab. Previous reports explored the introduction of the M3+ species, which required the simultaneous incorporation of a 5+ cation, as for the Bi4Ti3-2xNbxFexO12 system. A larger magnetic fraction might be attained if Ti4+ is substituted with Mn4+, though it has been argued that the small ionic radius prevents its incorporation into the pseudo-perovskite layer. We report here the mechanosynthesis of Aurivillius Bi4Ti2-xMnxNb0.5Fe0.5O12 (n = 3) compounds with increasing Mn4+ content up to x = 0.5, which corresponds to a magnetic fraction of 1/3 at the B-site surpassing the threshold for percolation, and equal amounts of Mn4+ and Fe3+. The appearance of ferromagnetic superexchange interactions and magnetic ordering was anticipated and is shown for phases with x ≥ 0.3. Ceramic processing was accomplished by spark plasma sintering, which enabled electrical measurements that demonstrated ferroelectricity for all Mn4+-containing Aurivillius compounds. This is a new family of layered oxides and a promising alternative single-phase approach for multiferroism.By means of the formation of SeN, the ABT-Se and NDI-Se were developed to detect and visualize endogenous hypobromous acid (HOBr) in live cells. Specifically, the upregulation of HOBr was monitored by NDI-Se during the administration of an immunotherapeutic agent.In order to explore the photocatalytic hydrogen production efficiency of the MoS2/WSe2 heterostructure (A2-MWS4) as a photocatalyst, it is highly desirable to study the photogenerated exciton dissociation related to photocatalysis. The electronic properties, optical absorption, and lattice dynamic properties of A2-MWS4 were investigated using a first-principles approach. The results show that the type II energy band alignment of A2-MWS4 facilitates the dissociation of photogenerated excitons (electrons and holes). The highly localized d-state electrons of A2-MWS4 induce the formation of internal potentials that promote the dissociation of photogenerated excitons. The hot carrier diffuses its extra energy into the lattice by scattering with phonons and forms a hot spot in the lattice while releasing phonons, which are dragged away from the hot spot by Ridley decay to promote exciton dissociation. These findings could provide insights for research studies on photochemical reactions and photovoltaic devices.Proton-exchange membrane fuel cells (PEMFC) offer a promising energy generation alternative for a wide range of technologies thanks to their ecological friendliness and unparalleled efficiency. At the heart of these electrochemical cells lies the membrane electrode assembly with its most important energy conversion components, the Proton Exchange Membrane. This component is created through the use of printing techniques and Nafion inks. The physicochemical properties of the ink, such as its viscosity under shear, are critical for the finished product. In this work we present non-equilibrium Molecular Dynamics simulations using a MARTINI based coarse-grained model for Nafion to understand the mechanism governing the shear viscosity of Nafion solutions. By simulating a Couette flow and calculating density maps of the Nafion chains in these simulations we shed light on the process that leads to the experimentally observed shear thinning effects of Nafion solutions under flow. We observe rod-shaped Nafion microstructures, 3 nm in size on average, when shear flow is absent or low. Higher shear rates instead break these structures and align Nafion strands along the direction of the flow, resulting in lower shear viscosities. Our work paves the way for a deeper understanding of the dynamic and mechanical properties of Nafion including studies of more complex CL and PEM inks.The sequentially fluorinated ferrocenes (1-, 1,2-di, 1,2,3-tri, 1,2,3,4-tetra and 1,2,3,4,5-pentafluoroferrocene) have been synthesized from ferrocene. Rather than a 'perfluoro' effect, experimental and computational analysis of the complete series robustly demonstrates a linear additive effect of fluorine on the electrochemical and spectroscopic properties of ferrocene.Reaction of a 3,4-diphenylsilole with two neopentasilanyl groups attached to the 2- and 5-positions with one equivalent of KOtBu did not result in the expected silanide formation but yielded a silole allylic anion instead. The initially formed silanide added to a neighboring phenyl group, which then transfers a proton to the 2-position of the silole ring.Correction for 'Synthesis, self-aggregation and cryopreservation effects of perylene bisimide-glycopeptide conjugates' by Xu He et al., Chem. Commun., 2021, DOI 10.1039/d1cc03835d.Metal-organic Frameworks (MOFs) have emerged as promising materials for different electrochemical applications. Their low conductivity, however, is a major challenge to overcome. Therefore, a deeper understanding on the charge transfer mechanism is needed to improve the conductivity of MOF-based electrodes. For this contribution, we focused on metalated MOF-525 and found that the nature of the metal center is one of the many factors contributing to the charge transfer kinetics, which is attributed to differences in redox behaviour, affecting the hopping distance and the electron transfer rate. These results highlight the importance of the nature of the redox active site to optimize charge transfer in MOF-based electrodes.A novel Mo-Sn catalyst for the oxidative coupling of methane was designed using a hydrothermal method. At 650 °C, the conversion of methane was 8.6% and the selectivity of the C2 hydrocarbons reached as high as 98.1% over the Mo1Sn3 catalyst, with a CO2 selectivity of only 0.8%. We demonstrated that the deep oxidation of methane to CO2 was further inhibited due to the synergistic effects of moderately strong basic sites and reactive oxygen species on the catalyst surface.Elevated concentrations of per- and polyfluoroalkyl substances (PFAS) in drinking-water supplies are a major concern for human health. It is therefore essential to understand factors that affect PFAS concentrations in surface water and groundwater and the transformation of perfluoroalkyl acid (PFAA) precursors that degrade into terminal compounds. Surface-water/groundwater exchange can occur along the flow path downgradient from PFAS point sources and biogeochemical conditions can change rapidly at these exchange boundaries. Here, we investigate the influence of surface-water/groundwater boundaries on PFAS transport and transformation. To do this, we conducted an extensive field-based analysis of PFAS concentrations in water and sediment from a flow-through lake fed by contaminated groundwater and its downgradient surface-water/groundwater boundary (defined as ≤100 cm below the lake bottom). PFAA precursors comprised 45 ± 4.6% of PFAS (PFAA precursors + 18 targeted PFAA) in the predominantly oxic lake impacted by a former fire-training area and historical wastewater discharges. In shallow porewater downgradient from the lake, this percentage decreased significantly to 25 ± 11%. PFAA precursor concentrations decreased by 85% between the lake and 84-100 cm below the lake bottom. PFAA concentrations increased significantly within the surface-water/groundwater boundary and in downgradient groundwater during the winter months despite lower stable concentrations in the lake water source. These results suggest that natural biogeochemical fluctuations associated with surface-water/groundwater boundaries may lead to PFAA precursor loss and seasonal variations in PFAA concentrations. Results of this work highlight the importance of dynamic biogeochemical conditions along the hydrological flow path from PFAS point sources to potentially affected drinking water supplies.A series of nickel(II) monobenzochlorins (MBCs) and monobenzoporphyrins (MBPs) containing β-appended or meso,β-fused indanedione (IND) or malononitrile (MN) groups were synthesized and characterized for their physicochemical, electrochemical and anion sensing properties. Each investigated compound contained four meso-phenyl rings and a single β,β'-fused 4,5-di(methoxycarbonyl)benzene ring, with the chlorins represented as NiMBC(Y)2(R)4 and the porphyrins as NiMBP(YF)2, where Y is an indanedione (IND) or malononitrile (MN) group, R = H or Br and YF is a meso,β-fused IND or MN substituent. One of the investigated compounds, NiMBP(IND)2, was structurally characterized and shown to possess a ruffled macrocyclic conformation. Epigenetic inhibitor order The monobenzochlorins, NiMBC(IND)2, NiMBC(IND)2Br4 and NiMBC(MN)2, reversibly respond to basic anions such as CN-, F-, OAc- and H2PO4- through a visible color change assigned to the deprotonation of the vicinal proton on the appended IND or MN substituents. The malononitrile-fused NiII monobenzoporphyrin, NiMBP(MN)2, exhibited a selective but irreversible visual detection of cyanide ions (LOD = 2.23 ppm). This reaction afforded a tri-fused π-extended monobenzoporphyrin product represented as NiMBP(VCN)2 (where VCN = meso,β-fused vinyl cyanide) in non-aqueous media and proceeded via anion induced electron transfer (AIET). The in situ generated π-extended porphyrin was also isolated and characterized as to its physicochemical and electrochemical properties and found to possess a narrow electrochemical HOMO-LUMO gap of 1.46 V along with a near-IR (NIR) absorption band located at 861 nm.Among the wealth of well-established molecular structures, inorganic rings and clusters present an overwhelming variety of geometries that chemists try to describe with a limited assortment of regular polygons and polyhedra. In the case of six-atom structures we usually employ the hexagon, the pentagonal pyramid, the trigonal prism and the octahedron. More often than not, however, real world structures deviate from those ideal geometries, and we try to cope with non-ideality by adding adjectives such as distorted, twisted, puckered or flattened, additionally nuanced by adverbs such as slightly, significantly or severely. This contribution presents a systematic structural perspective of six-atom groups in molecules by means of a continuous shape measures (CShM) analysis. The shape of a group of N points is defined by all the sets of 3 N Cartesian coordinates that can be generated by rigid translation, rotation, or isotropic scale change. Among all possible arrangements of N points in space, we select as reference shapes the corresponding regular N-vertex polygons and polyhedra, together with univocally defined combinations thereof (e.g., two coplanar or perpendicular edge-sharing squares). The present CShM study allows us to classify most of the structures not only by their closeness to a particular regular shape, but also by quantifying their position along minimal distortion interconversion pathways between two regular shapes.
Here's my website: https://www.selleckchem.com/pharmacological_epigenetics.html