Notes

A novel synchronised incomplete nitritation, denitratation along with anammox (SPNDA) procedure in sequencing batch reactor pertaining to innovative nitrogen elimination via ammonium as well as nitrate wastewater.
We propose the precise and wideband compensation of the nonlinear phase noise caused by cross-phase modulation (XPM) among WDM channels using a pilot tone (PT) and injection locking for short-reach, higher-order QAM transmission. A high spectral efficiency is maintained by sharing a single PT among multiple channels. We describe a 60 ch, 3 Gbaud PDM-256 QAM transmission over 160 km, where the bit error rate was improved from 6 × 10-3 to 2 × 10-3 by employing the proposed XPM compensation technique, with a spectral efficiency of 10.3 bit/s/Hz. We also analyze the influence of the group delay caused by fiber chromatic dispersion that determines the compensation range achievable with a single PT. We obtained good agreement with the experimental results.We propose a method of single-frame coherent diffraction imaging using a triangular aperture, which can not only reconstruct the projection image of extended objects from a single-frame coherent diffraction pattern, but also improve the image of the wavefield of the probe. In this method, a plane-wave illuminates a triangular aperture. An object is placed immediately after the aperture or in the image plane of the aperture through a lens. A far-field coherent diffraction pattern is collected by a two-dimensional detector. The object image is reconstructed from the single-frame diffraction pattern using a phase retrieval algorithm without support constraints. We simulate feasible experimental setups in the hard X-ray regime and show that this method can be practical use for single-frame coherent diffraction imaging. https://www.selleckchem.com/products/ml390.html The present method has the potential exploring dynamic phenomena in materials science and biology with high spatiotemporal resolution using synchrotron radiation/free-electron lasers.Interpretation of strong-field phenomena is mostly based on the analysis of classical electron trajectories in an intense laser field, whose specific properties determine general features of nonlinear laser-matter interaction. Currently, the visualization of closed electron trajectories contributing to high harmonic generation (HHG) of the laser field is the prerogative of a theoretical analysis based on the time-frequency spectrogram of the induced dipole acceleration. Here, we propose a method for direct reconstruction of the HHG time-frequency spectrogram using a time-delayed probe XUV pulse. Our analytical theory and ab initio numerical simulations demonstrate that the XUV-assisted HHG yield as a function of time delay and harmonic energy mimics the short-time Fourier transform of the dipole acceleration induced by the laser field, thereby providing possible in-situ experimental access for tracing electron dynamics in strong-field phenomena.In the conventional weighted Gerchberg-Saxton (GS) algorithm, the feedback is used to accelerate the convergence. However, it will lead to the iteration divergence. To solve this issue, an adaptive weighted GS algorithm is proposed in this paper. By replacing the conventional feedback with our designed feedback, the convergence can be ensured in the proposed method. Compared with the traditional GS iteration method, the proposed method improves the peak signal-noise ratio of the reconstructed image with 4.8 dB on average. Moreover, an approximate quadratic phase is proposed to suppress the artifacts in optical reconstruction. Therefore, a high-quality image can be reconstructed without the artifacts in our designed Argument Reality device. Both numerical simulations and optical experiments have validated the effectiveness of the proposed method.A measurement system based on a simple double-beam interferometry is built to realize the measurement of air refractive index with high accuracy. The basic principle of the system is that, through measuring the change of optical path difference caused by rapid and smooth vacuumization, measurement of refractive index of air is converted to length measurement. Error correction and signal processing are studied to ensure high-accuracy measurement of the refractive index of air. Three applicable methods are used in system. The system based on the methods realize the subdivision and counting of interference fringe by software with three-error correction, error compensation for the end-window plates' thickness change caused by vacuumization, steady realization of high vacuum conditions. To verify the accuracy and reliability of the system, the measurement results are compared with that obtained from the method based on empirical Edlén's formula. Analysis result shows that the expanded measurement uncertainty of the system is U = 5×10-9, with k = 2. The system can be used to compensate the laser wavelength error caused by the refractive index of air with high accuracy.Simultaneous control of phase and polarization offers a large degree of freedom to tailor the beam properties, for instance, enabling generation of structured beams such as vector beams and vector vortex beams. Here, we propose an ultrathin freestanding metasurface operating at the terahertz frequency for efficient generation of vector vortex beam with an arbitrarily defined topological charge from linearly polarized excitation. The metasurface is composed of bilayer metallic patterns separated by a thin quartz slab, with one layer determining the transmission polarization and the other controlling the transmission phase. The tightly cascaded two layers form a Fabry-Perot cavity to maximize the efficiency of the polarization and phase control. Two metasurfaces for generation of radially polarized vector beam with uniform phase and vortex phase are fabricated and tested at 0.14 THz. The experimental results successfully demonstrate the generation of high-quality vector beams with the desired phase. In the experiment, the ultrathin and freestanding properties allow the metasurface to be easily combined with other components, which shows great potential for the development of various compact terahertz systems.We propose and experimentally demonstrate a modular microring laser (MML) cavity for sensing applications. The proposed MML permits much more design freedom compared with a traditional simple ring cavity by decoupling the performance parameters into several regions in the cavity. Thus, the different biosensor performance parameters can be optimized semi-independently limiting the need for trade-offs on the design of the biosensing device. The first generation MML has been fabricated and tested. A fiber-to-fiber slope efficiency of up to 1.2%, a temperature coefficient of 1.35 GHz/K and a 3σ limit of detection (LOD) of 3.1 × 10-7 RIU without averaging and 6.0 × 10-8 RIU with a 60 s averaging, has been measured for the MML sensor, which is a record-low LOD in on-chip ring cavity optical sensors. Further optimization is possible, capitalizing on the key advantage of the MML concept, namely the potential for designing the laser cavity to achieve the desired optimization goals.
Website: https://www.selleckchem.com/products/ml390.html