Notes

Expert Feedback inside Translation Education: The Quasi-Experiment in a Superior Chinese-English Translation Program.
The fluorescence and physical properties of thulium and erbium co-doped dental zirconia were investigated. The high-translucency yttria-stabilized dental zirconia specimens co-doped with Tm2O3 powder 0.8 wt% and Er2O3 powder at proportions from 0.1 to 0.8 wt% were used. The specimens co-doped with Tm2O3 powder 0.8 wt% and Er2O3 from 0.3 to 0.5 wt% exhibited the fluorescence similar to that of natural tooth. All the specimens had a tetragonal peak and no major change in the Vickers hardness, fracture toughness and bending strength on addition of Tm2O3 and Er2O3. These results suggest that the method of co-doping trace amounts of Tm2O3 and Er2O3 into high-translucency dental zirconia powder can effectively improve the esthetics of zirconia monolithic fixed dental prothesis.This study aimed to examine whether discoloration of carious dentin after silver-diammine-fluoride (SDF) application might be used as a mean to detect demineralized-dentin. Fourty specimens were obtained from 20 human permanent teeth. Teeth were sectioned through the center of carious lesions to create 2-halves in which each half was assigned to a treatment group. Specimens were divided into two groups (n=20) (each half was assigned to one group) according to solution, namely Caries Check (CC), or SDF. SDF group was subdivided into 2 groups light-cured and 2-day storage groups. The specimens were tested using light-microscope, microhardness test and SEM/EDS analysis. Repeated-measures ANOVA was used for statistical analysis. The light-microscope showed superficial discoloration in the CC-group while SDF (2-day storage) group showed deeper discoloration for the lesion area. SDF showed significant increase in the hardness compared with the CC-group. SDF showed potentiality to be used as an assisting-tool for caries detection.This study evaluated the ability of different types of silver diammine fluoride (SDF) to inhibit dentin demineralization using micro-focused X-ray computed-tomography (µCT). Dentin specimens were divided into five groups (n=10); no-treatment (control), 3.8% SDF (RC), 38% SDF, 38% SDF with potassium iodide (SDF/KI), and potassium fluoride (KF). The treated-dentin surfaces were subjected to demineralization for 7-days and assessed using µCT to determine mineral loss (ML) values. Specimens were also analyzed with scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS). The ML values of the SDF and KF groups were significantly lower than those of the RC and SDF/KI groups. EDS detected fluoride ions in the SDF and KF groups but not in the RC and SDF/KI groups. It was concluded that 38% SDF demonstrated a high ability to inhibit dentin demineralization while additional application of KI may diminish the inhibitory effect of SDF. The amount of dentin demineralization with SDF treatments was material dependent.The purpose of this study was to investigate the influence of phosphoric acid etching, metal primer or silane coupling agent application on dentin bonding performance of a 2-step self-etch adhesive system. Human dentin surfaces were prepared and divided into four groups depending on the pre-treatment method no pretreatment (Clearfil SE Bond 2, CONTROL); 40% phosphoric acid (K-Etchant GEL, K); metal primer (Alloy Primer, AP); or silane coupling agent (Porcelain Bond Activator, PB). Atamparib ic50 The specimens were sectioned into beams, separated into 2 subgroups (n=20) no thermocyling or thermocycled (TC), and subjected to a µTBS test and an acid-base challenge for SEM observation. Statistically lower results were observed between K and AP groups, PB and CONTROL, and PB with/without TC (p less then 0.05). SEM images at the dentin-adhesive interface revealed that all groups produced an acid-base resistant zone (ABRZ), with a funnel-shaped erosion under the ABRZ for the K group.This study evaluated the bonding effectiveness of a newly developed two-step hydrophobic bonding material. Three groups using different bonding systems were compared BZF group, using the new bonding system (BZF-29; GC, Tokyo, Japan); GPB group, using a one-step bonding system (G-Premio Bond; GC); and SE2 group, using a two-step bonding system (CLEARFIL SE Bond 2; Kuraray Noritake Dental, Tokyo, Japan). Microtensile bond strength (µTBS) was measured after storage in water for 24 h, 3 months and 6months (n=25/group). Fracture surfaces were observed under scanning electron microscopy. The BZF group showed significantly higher µTBS than the other groups (p less then 0.001). Dominant failure patterns were cohesive failure for the BZF group (48-84%), mixed failure for the SE2 group (48-60%) and interface failure between adhesive and resin composite for the GPB group (48-52%). The hydrophobicity of the BZF-29 bonding system improves the long-term bonding effectiveness between adhesive and resin composite.
Extensive ablation in addition to pulmonary vein isolation (PVI) would be effective for modification of non-pulmonary vein (non-PV) substrates, whereas PVI might be sufficient for elimination of PV triggers. This study aimed to test the hypothesis that in patients with reproducible atrial fibrillation (AF) triggered by premature atrial contractions originating only from PVs, PVI alone can be sufficient to maintain sinus rhythm.Methods and ResultsThis study is a prespecified subanalysis of the EARNEST-PVI randomized controlled trial. This study investigated the efficacy of the PVI-alone strategy (PVI-alone) in comparison with the extensive strategy (PVI-plus) for persistent AF with a trigger-based mechanism vs. a substrate-based mechanism. Patients were stratified into 3 groups based on AF mechanisms (1) Substrate group (N=236); (2) PV trigger group (N=236); and (3) non-PV trigger group (N=24). The hazard ratios for AF recurrence of the PVI-alone strategy with reference to the PVI-plus strategy were 1.456 (95% confidence interval [CI] [0.864-2.452]) in the substrate group, 1.648 (95% CI 0.969-2.801) in the PV trigger group, and 0.937 (95% CI 0.252-3.488) in the non-PV trigger group. No significant interaction between ablation strategy and AF mechanism was observed (P for interaction=0.748).

This study indicated that the efficacies of the PVI-alone strategy compared with the PVI-plus strategy were consistent across persistent AF with trigger-based and substrate-based mechanisms.
This study indicated that the efficacies of the PVI-alone strategy compared with the PVI-plus strategy were consistent across persistent AF with trigger-based and substrate-based mechanisms.
My Website: https://www.selleckchem.com/products/rbn-2397.html