Notes

Relevance as well as arrangement involving being overweight anthropometric sizes along with indices in adults: a new population-based study on the actual Uae.
In this study, an optical manipulation and micro-surface-enhanced Raman scattering (microSERS) setup based on a microcavity was developed for efficient capture of gold nanoparticles using the photothermal effect. In addition, optical manipulation of gold nanoparticles and SERS signal detection were performed using only one laser. The results show that the SERS enhancement effect based on the microcavity was more than 20 times that based on a gold colloid solution. The laser power and velocity of nanoparticles exhibited a good linear relationship, and the velocity of nanoparticles decreased with decreasing radius r, which verifies the detriment of the radial thermophoresis in this study. This method can be used to quickly and efficiently drive metal nanoparticles and provides a promising approach for analysis of substances in the fields of chemistry and biology.We developed a high power optical parametric chirped-pulse amplification (OPCPA) system at 2.1 µm harnessing a 500 W YbYAG thin disk laser as the only pump and signal generation source. The OPCPA system operates at 10 kHz with a single pulse energy of up to 2.7 mJ and pulse duration of 30 fs. The maximum average output power of 27 W sets a new record for an OPCPA system in the 2 µm wavelength region. The soft X-ray continuum generated through high harmonic generation with this driver laser can extend to around 0.55 keV, thus covering the entire water window (284 eV - 543 eV). With a repetition rate still enabling pump-probe experiments on solid samples, the system can be used for many applications.Optical remote sensors are nowadays ubiquitously used, thanks to unprecedented advances in the last decade in photonics, machine learning and signal processing tools. In this work we study experimentally the remote recovery of audio signals from the silent videos of the movement of optical speckle patterns. This technique can be used even when in between the source and the receiver there is a medium that does not allow for the propagation of sound waves. We use a diode laser to generate a speckle pattern on the membrane of a loudspeaker and a low-cost CCD camera to record the video of the movement of the speckle pattern when the loudspeaker plays an audio signal. We perform a comparative analysis of six signal recovery algorithms. In spite of having different complexity and computational requirements, we find that the algorithms have (except for the simplest one) good performance in terms of the quality of the recovered signal. The best trade-off, in terms of computational costs and performance, is obtained with a new method that we propose, which recovers the signal from the weighted sum of the intensities of all the pixels, where the signs of the weights are determined by selecting a reference pixel and calculating the signs of the cross-correlations of the intensity of the reference pixel and the intensities of the other pixels.With advances in nanofabrication techniques, extreme-scale nanophotonic devices with critical gap dimensions of just 1-2 nm have been realized. The plasmonic response in these extreme-scale gaps is significantly affected by nonlocal electrodynamics, quenching field enhancement and blue-shifting the resonance with respect to a purely local behavior. The extreme mismatch in lengthscales, ranging from millimeter-long wavelengths to atomic-scale charge distributions, poses a daunting computational challenge. In this paper, we perform computations of a single nanoslit using the hybridizable discontinuous Galerkin method to solve Maxwell's equations augmented with the hydrodynamic model for the conduction-band electrons in noble metals. This method enables the efficient simulation of the slit while accounting for the nonlocal interactions between electrons and the incident light. We study the impact of gap width, film thickness and electron motion model on the plasmon resonances of the slit for two different frequency regimes (1) terahertz frequencies, which lead to 1000-fold field amplitude enhancements that saturate as the gap shrinks; and (2) the near- and mid-infrared regime, where we show that narrow gaps and thick films cluster Fabry-Pérot (FP) resonances towards lower frequencies, derive a dispersion relation for the first FP resonance, in addition to observing that nonlocality boosts transmittance and reduces enhancement.Broadband high-speed absorption spectroscopy using swept-wavelength external cavity quantum cascade lasers (ECQCLs) is applied to measure multiple pyrolysis and combustion gases in biomass burning experiments. Two broadly-tunable swept-ECQCL systems were used, with the first tuned over a range of 2089-2262 cm-1 (4.42-4.79 µm) to measure spectra of CO2, H2O, and CO. The second was tuned over a range of 920-1150 cm-1 (8.70-10.9 µm) to measure spectra of ammonia (NH3), ethene (C2H4), and methanol (MeOH). Absorption spectra were measured continuously at a 100 Hz rate throughout the burn process, including inhomogeneous flame regions, and analyzed to determine time-resolved gas concentrations and temperature. The results provide in-situ, dynamic information regarding gas-phase species as they are generated, close to the biomass fuel source.A better lateral current confinement is essentially important for GaN-based vertical-cavity-surface-emitting lasers (VCSELs) to achieve lasing condition. Therefore, a buried insulator aperture is adopted. However, according to our results, we find that the current cannot be effectively laterally confined if the insulator layer is not properly selected, and this is because of the unique feature for GaN-based VCSELs grown on insulating substrates with both p-electrode and n-electrode on the same side. Our results indicate that the origin for the current confinement arises from lateral energy band bending in the p-GaN layer rather than the electrical resistivity for the buried insulator. https://www.selleckchem.com/products/grl0617.html The lateral energy band in the p-GaN layer can be more flattened by using a buried insulator with a properly larger dielectric constant. Thus, less bias can be consumed by the buried insulator, enabling better lateral current confinement. On the other hand, the bias consumption by the buried insulator is also affected by the insulator thickness, and we propose to properly decrease the insulator layer thickness for reducing the bias consumption therein and achieving better lateral current confinement.
Here's my website: https://www.selleckchem.com/products/grl0617.html