Notes

Chance of radiation-induced second dangerous neoplasms through photon and also proton radiotherapy inside paediatric abdominal neuroblastoma.
Regardless of the shape of the closed loops, such topological wetting states can always arise due to the topological invariant (i.e., all closed loops entail the same topological genus value). This unusual wetting behavior is contrary to the conventional view (and to the prediction of the Wenzel equation), namely, a rough hydrophilic surface should have stronger hydrophilicity than its flat-surface counterpart.Brassinosteroids (BRs) are known to regulate plant growth and development. However, only little is known about their mechanism in the regulation of berry development in grapes. This study demonstrates that BR treatment enhances the accumulation of fruit sugar components, reduces the content of organic acids (e.g., tartaric acid), promotes coloration, and increases the anthocyanin content in grape berries at the onset of the veraison, half veraison, and full veraison stages at the rate of 0.0998, 0.0560, and 0.0281 mg·g-1, respectively. In addition, BR treatment was also found to accelerate the biosynthesis of terpenoid aroma components, such as α-pinene, d-limonene, and γ-terpinene, which influence the aromatic composition of grapes. BRs can negatively regulate the expression of VvHMGR, a key gene involved in the mevalonate (MVA) pathway, and reduce the activity of 3-hydroxy-3-methylglutaryl CoA reductase (HMGR). Inhibiting the expression of HMGR promoted the accumulation of anthocyanins and fruit coloration. Meanwhile, after the inhibition, the contents of auxin indole-3-acetic acid (IAA), abscisic acid (ABA), and brassinosteroid (BR) increased, while gibberellin (GA3) and zeatin riboside (ZR) decreased, and its aromatic composition also changed. Therefore, it may be concluded that BRs inhibited HMGR activity and cooperated with VvHMGR to regulate the formation of color, aroma, and other quality characteristics in fruits.Tuberculosis (TB), one of the deadliest infectious diseases, is caused by Mycobacterium tuberculosis (MTB) and remains a public health problem nowadays. Conventional MTB DNA detection methods require sophisticated infrastructure and well-trained personnel, which leads to increasing complexity and high cost for diagnostics and limits their wide accessibility in low-resource settings. To address these issues, we have developed a low-cost photothermal biosensing method for the quantitative genetic detection of pathogens such as MTB DNA on a paper hybrid device using a thermometer. First, DNA capture probes were simply immobilized on paper through a one-step surface modification process. After DNA sandwich hybridization, oligonucleotide-functionalized gold nanoparticles (AuNPs) were introduced on paper and then catalyzed the oxidation reaction of 3,3',5,5'-tetramethylbenzidine (TMB). The produced oxidized TMB, acting as a strong photothermal agent, was used for the photothermal biosensing of MTB DNA under 808 nm laser irradiation. Under optimal conditions, the on-chip quantitative detection of the target DNA was readily achieved using an inexpensive thermometer as a signal recorder. This method does not require any expensive analytical instrumentation but can achieve higher sensitivity and there are no color interference issues, compared to conventional colorimetric methods. The method was further validated by detecting genomic DNA with high specificity. To the best of our knowledge, this is the first photothermal biosensing strategy for quantitative nucleic acid analysis on microfluidics using a thermometer, which brings fresh inspirations on the development of simple, low-cost, and miniaturized photothermal diagnostic platforms for quantitative detection of a variety of diseases at the point of care.Various mechanisms of obesity prevention have been identified; however, the roles of brown or beige fat as regulators of the energy balance are unclear. The effects of anthocyanin-rich black soybean, Glycine max (L.) Merr., testa (ABS) extracts on the energy balance were investigated by comparing beige-like adipocytes (BLA) and white adipocytes (WAT). ABS extracts reduced peroxisome proliferator-activated receptor gamma protein expression and triglyceride accumulation in WAT and BLA without inducing nuclear damage. The biomarkers of fat degradation (phospho-AMPKα and ATGL) or glycerol secretion in the medium and β-oxidation of fatty acids (CPT2) in the ABS-treated BLA were increased compared to those in WAT. ABS extracts significantly increased the expression of thermogenesis markers (UCP1 and CIDEA) and biomarkers related to mitochondrial activation (cytochrome c and NRF1) in BLA. GSK2126458 In the primary cell culture of brown adipocytes (BAT) from rats fed ABS, the expression levels of PGC1-α, cytochrome c, and UCP1 proteins were increased compared to those in BAT from nonfed rats. link2 A reduction in the NAD/NADH ratio was consistently associated with an increase in the oxygen consumption rate and basal/maximal respiration rate in ABS-treated BLA. Anthocyanins promote beiging in the body, contribute to the prevention of obesity, and are potentially useful functional materials.CuI has been recently rediscovered as a p-type transparent conductor with a high figure of merit. Even though many metal iodides are hygroscopic, the effect of moisture on the electrical properties of CuI has not been clarified. In this work, we observe a 2-fold increase in the conductivity of CuI after exposure to ambient humidity for 5 h, followed by slight long-term degradation. Simultaneously, the work function of CuI decreases by almost 1 eV, which can explain the large spread in the previously reported work function values. The conductivity increase is partially reversible and is maximized at intermediate humidity levels. On the basis of the large intragrain mobility measured by THz spectroscopy, we suggest that hydration of grain boundaries may be beneficial for the overall hole mobility.The nonequilibrium Fermi's golden rule (NE-FGR) describes the time-dependent rate coefficient for electronic transitions when the nuclear degrees of freedom start out in a nonequilibrium state. In this paper, the linearized semiclassical (LSC) approximation of the NE-FGR is used to calculate the photoinduced charge transfer (CT) rates in the carotenoid-porphyrin-C60 molecular triad dissolved in explicit tetrahydrofuran. The initial nonequilibrium state corresponds to impulsive photoexcitation from the equilibrated ground state to the ππ* state, and the porphyrin-to-C60 and carotenoid-to-C60 CT rates are calculated. Our results show that accounting for the nonequilibrium nature of the initial state significantly enhances the transition rate of the porphyrin-to-C60 CT process. link3 We also derive the instantaneous Marcus theory (IMT) from LSC NE-FGR, which casts the CT rate coefficients in terms of a Marcus-like expression, with explicitly time-dependent reorganization energy and reaction free energy. IMT is found to reproduce the CT rates in the system under consideration remarkably well.In estuaries, salinity fluctuates rapidly and continuously, greatly affecting the bioavailability and thus toxicity of contaminants, especially metals, causing difficulties in deriving site-specific water quality criteria. We developed a method for predicting the toxicity of the metal cadmium (Cd) in estuarine waters of any salinity fluctuation scenario. Cd bioaccumulation and toxicity were measured in an estuarine clam Potamocorbula laevis under stable salinities (salinity = 5, 15, 25) and fluctuating salinities (5-25), using the toxicokinetic-toxicodynamic (TK-TD) framework. Cd bioaccumulation decreases with increasing salinity; whereas intrinsic Cd sensitivity of organisms reaches the minimum at an intermediate salinity around 20. At each specific Cd level, interpolating TK-TD parameters measured at the stable salinities well predicts the Cd bioaccumulation and toxicity under fluctuating salinities. To extend the model for various Cd levels, the biotic ligand model (BLM) was integrated into the TK-TD framework. The BLM-based TK-TD model was successfully applied to scenarios of simulated and monitored salinity fluctuations in estuarine waters, for which the median lethal concentrations and no-effect concentrations (2.0-3.1 μg L-1) of Cd were derived. Overall, we integrated the BLM and TK-TD models and provided a useful tool for predicting metal risks and deriving criteria values for salinity-fluctuating estuarine waters.Carbendazim (CBZ), which is a fungicide widely used for the management of plant diseases, has been detected in a number of food products. The negative effects of CBZ to human health have stimulated the reduction of the maximum residue limits (MRLs), and subsequently the development of reliable and sensitive detection methods. Here, we are reviewing for the first time all reported chromatographic methods for the detection and quantification of CBZ in food. Several techniques, including liquid chromatography (LC), thin layer chromatography (TLC), micellar electrokinetic chromatography (MEKC), and supercritical fluid chromatography (SFC), were used for the separation and detection of CBZ, showing diverse characteristics and sensitivity. Some methods allowed the specific determination of CBZ, whereas other methods were successfully applied for the simultaneous quantification of a huge number of pesticides. Most reported methods showed limits of detection (LOD) and quantification (LOQ) lower than the MRLs. Relevant efforts in the field have been directed toward the simplification and optimization of the extraction steps prior to the chromatographic separation to increase the recovery and reduce the matrix effects. In this Review, the matrices, extraction procedures, and separation and detection parameters are detailed and compared in order to provide new insights on the development of new reliable methods for the detection of CBZ in food.Obtaining a perovskite light-absorbing layer with good crystallization, low defect concentration, good stability, and well-matched energy levels is critical to obtaining high-efficiency perovskite solar cells (PSCs). Here, a hybrid PSC with a graded band gap is explored using MAPbBr3 (MA = CH3NH3) and MAPbBr0.9I2.1 quantum dots (QDs) as component cells. We have creatively designed a solar cell device with a double-QD structure [indium tin oxide (ITO)/SnO2/perovskiteMAPbBr3 QDs/MAPbBr0.9I2.1 QDs/Spiro-OMeTAD/Au]. A better crystal film of the perovskite absorption layer can be obtained because the MAPbBr3 QDs are doped in an antisolvent, which induces nucleation and growth in the polycrystalline perovskite. In addition, we expect that digestive ripening occurred in the crystallization, and the oleic acid ligands on the surface of the QDs disintegrate during the doping process and transfer to the surface of the perovskite absorption layer finally; it follows that the hydrophobicity and stability of the perovskite film are greatly enhanced. Moreover, a thin film of MAPbBr0.9I2.1 QDs is introduced between the perovskite absorption layer and the hole layer, acting as an energy-level ladder, which leads to well-matched energy levels, an increase in fill factor (FF), and an enhanced hole transport capability. In particular, the mechanism of the crystallization process involving the effect of oleic acid ligands on the interior and surface of the perovskite film is fully discussed here. The final research results from the PSCs show that both high efficiency and long-term stability are achieved successfully by this design strategy.
Homepage: https://www.selleckchem.com/products/gsk2126458.html