Notes

Installing a Fish Finder
Installing a fish finder does take some technical skill however, with a little determined effort and several forethought you are able to put in a fish finder like a pro. The first item can be to think about the location. Make sure to choose a location that will enable enough space to route the wiring and also a surface for optimal viewing. Keep in try this web-site that sunlight can sometimes spark a fish finder display to seem dim. A flush mount kit can be acquired if installing on a panel or most units feature a bracket that allows the device to get removed as needed. Also, be sure to install the product in a place that'll be relatively free of water intrusion whenever possible. A high quality fish finder will resist most water but being careful to avoid it all together will ensure a new fish finder gives you a lot of service.

The second step is always to install the transducer. Time needs to be come to properly plan this as improper placement can create a complete malfunction along with the fish finder may well not read in any way (refer to owners manual for optimal placement.) Never cut the transducer cable try to mount the transducer so that it is parallel for the bottom of the vessel. Never mount in a location which is in the path from the propeller. Make sure to supply sufficient water depth, usually just under the boat hull, if mounting for the transom. Take caution here, the fish finder might not exactly read correctly while under way or else mounted below the hull. Also, if the boat is over a trailer ensure that the mounting location will not be prone to damage when launching. One last important item, only use the right sealant when drilling mounting holes below water line. Depending on the installation, your fish finder will probably have to have a few mounting holes drilled to mount the transducer. Now install the wiring harness and route the transducer cable. Take care when routing the transducer cable because keeping the wiring from other electrical wires might help minimize the potential for electrical interference. The display for the fish finder could show noise, for instance; turning with a wash down pump or live well pump. The electrical connections must be made while using proper procedures found inside installation guide in the manufacturer. Never connect wiring with all the assumption that specific colors are for particular things! The standard wiring harness over a fish finder will usually possess a black wire for any ground plus a red for power but browse the instructions (MEN).

Some fish finders have an overabundance of wires to power other components or communications to marine electronics. Never connect wires if you are unsure and try to perform proper research to your particular fish finder to successfully use a reliable wiring diagram. Overall installation should also take into account that a fish finder is an expensive device in your boat. The wiring should simply be employed for the purpose with the fish finder and many types of connections needs to be sealed well making well. Any time holes are drilled they need to not be sealed with mounting screws alone, but in addition sealing compound. Check the manufacturer's suggestion in the manual of one's fish finder to find out an approved sealant. Above all, make sure you read the owner's manual that accompanies your fish finder. Don't forget to take pleasure in the good days, and appearance toward better days for the bad ones. The big you are one cast away.
Homepage: https://www.marine-electronics.com.au/