Notes

What Makes AF 2 CW Different From Other RF Modulators?
AF 2 CW is an RF modulator that employs a search space for blind decoding. Learn More features a SWEEP OUTPUT connector for a X-Y recorder and a computer's memory for a calibration data checksum. This article explains what makes it different from other RF modulators. Read on for more information. Also, find out how to set the search space and X-Y recorder's X-Y recording.

https://af2cw.com/ is a RF modulator

The AF-2 CW is a frequency-variable RF modulator that features an XTAL filter with six 6,400-MHz crystal units. The RF signal is modulated at a rate that is proportional to the XTAL filter's bandwidth. There is no switch for switching between CW and SSB modes. The RF signal can be activated by pressing the KEY or PTT button. CW mode has priority over SSB mode.

This RF modulator is commonly integrated into VCRs, video game consoles up to fourth generation, and eight-bit home computers. It is capable of converting video and audio signals into the broadcast RF signal that can be fed into a television aerial connector. This modulator is also compatible with HD televisions and supports ATSC, DVBT, DVBC, and DMBT.

It uses a search space for blind decoding

The UE design for AF 2 CW is based on a search space for blind decoding, where the UE only needs to perform a small number of blind decodes to fit the payload. The UE decodes the payload using a set of candidates found within each subframe. The PCFICH channel also uses blind decoding. The UE is assigned a specific search space containing a fixed number of symbols that are used to carry control information.

The UE's ability to decode a downlink control signal may be limited by the amount of data available. Blind detection for a downlink control signal may involve trial and error and may require multiple decoding attempts for different payload sizes. Future evolution of transmission techniques may require that UEs support additional bits in downlink control signaling, which will increase the complexity burden on the UE.

It uses a SWEEP OUTPUT connector for X-Y recorder

Graphic X-Y recorder, is a device that produces a graphic record of an electrical signal. This recording device has a reference slotted line with a reference termination 14 connected to the unit under test. The measurement probe (16) picks up a signal from the unit under test and supplies it to an amplifier 19. The amplifier then provides an X-axis input to the recording device 21. The X-axis input is provided by the sweep oscillator 2.

It uses a computer's memory for calibration data checksum

The AF-2 CW system uses the memory of a computer to store the calibration data checksum. This system is integrated into the vehicle system 11, which includes an Engine Control Unit (ECU) coupled to the engine 16 via an actuator. The system includes software for calibration, which is based on the Delphi Personal Computer Calibration Development System software. The software was originally designed to control external ROM emulation, but it was later modified to function with chips that have built-in memory protection.

The calibration data checksum stored in the memory of a computer is generated from a computer's memory by a hardware algorithm. The calibration data checksum is calculated by comparing the RF signal's frequency with the frequency of the computer's memory. The resulting RF signal is then converted into a frequency value that matches the signal of the target. Using this data, the AF-2 CW is able to determine if the RF signal is from a cellular phone or an infrared signal from a laser pointer.
Website: https://www.ultimate-guitar.com/u/liftsandra9