Notes

Installing a Fish Finder
Installing a fish finder does take some technical skill however, with some elbow grease and some forethought you can purchase a fish finder being a pro. The first item is to take into account the location. Make sure to choose a location that will permit enough space to route the wiring in addition to a surface for optimal viewing. Keep in mind that sunshine can on occasion spark a fish finder display to look dim. A flush mount kit can be bought if installing on a panel or most units include a bracket that allows the system being removed as needed. Also, remember to install these devices in a very place which will be relatively free from water intrusion if possible. A high quality fish finder will resist most water but being careful in order to avoid it all together will assure your fish finder gives you a lot of service.

The next step would be to install the transducer. Time ought to be taken up properly plan this as improper placement can spark a complete malfunction as well as the fish finder might not exactly read whatsoever (refer to owners manual for optimal placement.) Never cut the transducer cable try to mount the transducer so that it is parallel for the bottom with the vessel. Never mount in the location that's inside path of the propeller. Make sure to supply sufficient water depth, usually just underneath the boat hull, if mounting about the transom. Take Lowrance transducer , the fish finder may well not read correctly while under way or even mounted below the hull. Also, when the boat is on a trailer ensure the mounting location are not susceptible to damage when launching. One last important item, always employ the best sealant when drilling mounting holes below the river line. Depending on your installation, your fish finder will most likely require a few mounting holes drilled to mount the transducer. Now install the wiring harness and route the transducer cable. Take care when routing the transducer cable because keeping the wiring far from other electrical wires can help minimize the potential of electrical interference. The display on the fish finder could show noise, by way of example; turning over a wash down pump or live well pump. The electrical connections should be made while using proper procedures found inside installation guide through the manufacturer. Never connect wiring while using assumption that particular colors are for particular things! The standard wiring harness with a fish finder will most likely have a very black wire for a ground and a red for power but see the instructions (MEN).

Some fish finders have an overabundance wires to power other components or communications along with other marine electronics. Never connect wires should you be unsure and try to perform the proper research for the particular fish finder to ensure that you have a very reliable wiring diagram. Overall installation also need to consider that a fish finder can be an expensive item of equipment in your boat. The wiring should only be used for the purpose with the fish finder and all sorts of connections ought to be sealed well making well. Any time holes are drilled they need to not sealed with mounting screws alone, but in addition sealing compound. Check the manufacturer's suggestion inside the manual of the fish finder to find out an approved sealant. Above all, be sure you read the owner's manual that accompanies your fish finder. Don't forget to take pleasure in the good days, and search to better days for the bad ones. The big one is just one single cast away.
My Website: https://www.marine-electronics.com.au/