Notes

Installing a Fish Finder
Installing a fish finder does take some technical skill however, with some elbow grease plus some forethought you'll be able to put in a fish finder just like a pro. The first item can be to look at the location. Make sure to choose a location that will permit enough space to route the wiring and a surface for optimal viewing. Keep in mind that direct sunlight can on occasion result in a fish finder display to seem dim. A flush mount kit can be acquired if installing on the panel or most units have a bracket which allows the unit to be removed if needed. Also, don't forget to install the device inside a place that will be relatively totally free of water intrusion whenever possible. A high quality fish finder will resist most water but the constant maintenance to stop it all together will ensure your brand-new fish finder provides you with many years of service.

The alternative is to install the transducer. Time should be taken to properly plan this as improper placement can cause a complete malfunction and also the fish finder may not read whatsoever (refer to owners manual for optimal placement.) Never cut the transducer cable and try to mount the transducer so that it is parallel towards the bottom from the vessel. Never mount in a very location that is certainly inside the path with the propeller. Make sure to supply sufficient water depth, usually just underneath the boat hull, if mounting about the transom. Take caution here, the fish finder may well not read correctly while under way or even mounted below the hull. Also, when the boat is with a trailer ensure that the mounting location are not susceptible to damage when launching. One last important item, always employ the correct sealant when drilling mounting holes below the lake line. Depending in your installation, your fish finder will probably require a few mounting holes drilled to mount the transducer. Now install the wiring harness and route the transducer cable. Take care when routing the transducer cable because keeping the wiring away from other electrical wires may help minimize the potential for electrical interference. The display about the fish finder could show noise, for instance; turning on a wash down pump or live well pump. The electrical connections needs to be made with all the proper procedures found in the installation guide through the manufacturer. Never connect wiring while using assumption any particular one colors are for particular things! The standard wiring harness over a fish finder will most likely have a black wire for any ground as well as a red for power but look at instructions (MEN).

Some fish finders have an overabundance wires to power other components or communications with other marine electronics. Never connect wires in case you are unsure try to perform the proper research on your particular fish finder to make sure you use a reliable wiring diagram. Overall installation also needs to consider that a fish finder is an expensive piece of equipment on your own boat. The wiring should basically be useful for the purpose from the fish finder and all connections should be sealed well generating well. Furuno transducer are drilled they should stop sealed with mounting screws alone, and also sealing compound. Check the manufacturer's suggestion within the manual of the fish finder to ascertain an approved sealant. Above all, make sure to browse the owner's manual that accompanies a new fish finder. Don't forget to benefit from the good days, and search toward better days for the bad ones. The big an example may be just one single cast away.
Homepage: https://www.marine-electronics.com.au/