Notes

7 Steps to Install Your Cubicles
It is essential when installing toilet or shower cubicles to adhere to procedures. Preparation is paramount also to over look these simple instructions may cause big problems afterwards in the installation process. Now ensure you supply the components required to install your cubicle. Just follow these straightforward instructions, making certain your lines are vertical because you have areas like floors or walls, that may be from true, as well as your cubicles will likely be installed in almost no time in any respect.
Step 1 Measuring up
Measure and mark off a vertical line for the back wall to the positions from the wall partitions to the cubicles. Mark about the wall the positions to fix these back wall brackets.
Step 2 Fitting Brackets
Fix the 3 back wall channel brackets as required for each partition about the vertical line drawn for the wall.
Step 3 Fitting Partitions
Position the wall panels into the brackets and be sure the partition is level while using the adjustable legs fixed to the wall panels.
Draw the complete position in the holes inside the channel brackets for the walls of each and every partition ready for drilling. Drill the hole using a 10mm drill bit and connect the brackets to the partition walls using the T-nuts provided.
Step 4 Fitting Partition Support
Check the attached the adjustable leg to the partition, and adapt to correct height. Ensure the partition is aligned correctly and connect adjustable legs towards the floor.
Step 5 Fitting Fascia Panels
Measure up and mark off a vertical line about the side wall if fixing to some wall. Fix the 3 wall brackets the wall. Make sure the hinge panel is level and mark over positions from the 3 brackets about the fascia. Fix the hinge wall to fascia channel brackets while using T-nuts provided. Your pilaster (central fascia panel) could have the hinge holes pre-drilled and just fix those with all the T-nuts provided.
Step 6 Fitting Head Rail
With the partitions and fascia fixed the pinnacle rail should be put in position on the tops from the fascia bridging the threshold gap. Fix the head rail permanently by attaching on the fascia.
Step 7 Fitting the doors, hinges and lock assembly
Attach the hinges for the doors. Attach the indicator bolt towards the door. Block the doors up to the level with the hinge panel bottom using wood and put the entranceway around the blocks. Engage stone wall cladding panels and mark off of the indicator bolt for the fascia at the point you would like to attach the keep. Mark off the hinge placement about the hinge panel. To drill the hinge holes get rid of the nut at the bottom of the hinge and reassemble and fix the hinges for the walls ensuring the doorway is hung horizontal. Unlock the indicator bolt and fasten the keep while using the fixings provided. Set back the plastic sleeves inside the hinge to the door to seal closed or open.
Here's my website: https://userscloud.com/t9zx37h7ecqw