Notes

Your Family Will Be Grateful For Having This Renault Key Ring
Repairing Faulty Renault Clio Key Fobs

Renault has transformed the Clio by introducing the fifth generation model. The interior of the new Clio is far superior to the earlier model, and has a more refined driving environment.

It also boasts one of the largest infotainment displays in this class - between 7 and 10 inches depending on the specs. Additionally, it's loaded with features that make it an extremely highly competitive supermini.

Dead coin battery

If your Clio key fob isn't working, try replacing the battery. It is simple to replace the battery at home since it is typically of the button cell type. However, it is essential to choose the correct voltage, size and type of battery for the job. Avoid letting the battery contact your skin. This can cause damage to the electronic chip on the key fob because of moisture and oils.

Normally the battery will begin to run out of power before it dies. You might be noticing that your car won't start after you press the ignition switch. Then the key fob will be able to click, but it won't crank. This indicates that the battery for the coin-cell is close to its end.

Another reason that could cause the key fob's device to stop working is interference. It could be due to transmitters operating on the same frequency band, bad weather conditions, or damaged electronic components. Remote controls work when you're close to the car, but not at some distance.

If the key fob isn't working, you can try to reset it by disconnecting the battery at 12 volts for a short period of time. Remove the negative terminal prior to the positive. This will drain all the remaining electricity from your system.

Water damage

The Renault Clio has a lot of character, and it's equipped with some great technology. There are a few issues with the tiny French fighter. Particularly with regard to keyfobs. These devices can be a challenge to handle, however there are ways to get them out of the way.

Electronics and water do not blend well, and may damage the chip in the fob. The splash of water from a shower or bath is fine, however submerging the fob into a pool of ocean or water could damage it. This is especially relevant if salt is present in the water. It can be more damaging than tap water.

If your key fob has been submerged in water, it's best to clean it promptly using isopropyl alcohol or an electronic cleaner. This will stop the water from damaging the chip and also remove any dirt or grime that might be blocking the circuitry.


You can attempt to fix your fob using the battery once it is dry. If you can't get it to work, it's probably better to buy an entirely new one. Be wary of buying secondhand key cards on eBay because they can't be programmed to your car.

Key fobs that may be defective

Faulty key fobs can cause problems for your vehicle's RKE system, including failing to close the doors, or not getting the vehicle started. This issue could be caused by wireless devices transmitting at the same frequency as the key fob. These include aftermarket radar detectors and alarms. They may interfere with the signal of the key fob to the receiver module.

When your key fob stops functioning The first thing to examine is its battery. The batteries that are found in modern key fobs are made to last a long time. However, they will eventually wear down and need to replace. One of the main signs that a keyfob's battery is wearing out is the loss of signal strength and range.

With a few simple steps it is possible to replace the battery in your key fob. The site of the manufacturer usually has instructions and YouTube has a wealth of videos showing how to replace the battery in your particular vehicle model.

If you can't replace the battery of your key fob, you should try to start your vehicle using the backup system, which is possible in many vehicles. In the majority of cases, you'll have to close the doors to your car and then press the fob's start button with the physical key. If you're unable to start the car using this method, contact a mechanic or an expert to pinpoint the issue.

The receiver module is not working properly.

A damaged receiver module inside the Renault Clio can cause the remote keyless system to not work. This could also affect other car systems, such as the infotainment system. The problem may be caused by an unresponsive 12 volt battery or signal interference, or even a defective electronic chip. To fix the issue remove the 12 volt battery from your vehicle. Use a multimeter and check the voltage of each fuse in your fuse box. Replace any fuses that have blown.

The most typical reason for a malfunctioning Renault Clio remote key is a dead battery for the coin. The issue could be caused by worn buttons and poor contact of batteries to the metal clips on the key fob, or water damage. It is usually possible to replace the battery by following the instructions provided in your owners manual. It is essential to make sure that the replacement battery is of the correct size and voltage.

renault clio replacement key cost inside the key fob could be damaged when exposed to excessive sunlight, water or other electromagnetic fields. It can also be corrupted by radio transmitters that operate on the same frequency as the key fob. In these cases the transmitter of the key fob may operate locally, but not from a distance. It is possible to fix this problem by reprogramming the key using an OBDII scan or following the instructions in your owner's guide.

Website: https://www.thekeylab.co.uk/renault-car-keys/