Notes

The Pressure Washing Equipment in Trailer Essentials

When purchasing a new pressure washing truck setup, look for absolute minimums. additional info The specifications and features below are the minimum requirements. Anything more is an upgrade to better meet your needs.




Ability to heat water
Hot water is the finest technique to increase cleaning efficiency because time is money in this profession. Because hot water has more heat, it can penetrate the surface to loosen organic matter.

Three plungers and a pump
The most muscular direct-drive triplex plunger pumps offer water flow rates of 4.5 GPM at 5,000 PSI. The CAT Pumps model with these specifications has an internal gear reducer and needs a gas engine to produce about 20 HP.

Engine for industrial-duty use
An industrial engine is required to power the robust triplex plunger pump. The GX690 has a 22 HP output at 3600 rpm and is Honda's largest compact engine.

Holding a hose in place with a reel
Hose reels are typically found on pressure-cleaning trailers in one of the following four categories:

1. Hand crank: Turn the hose by using your muscles.
2. Once you pull the hose out, a spring-driven hose will instantly reel itself in. Give it a gentle tug to activate it.
3. Pushing the button will start the electric motor that reels the hose.
4. Combining pivoting and one of the previously mentioned retracting techniques: A pivoting hose reel mounts to an arm, can rotate approximately 150 degrees.

Tank for fuel
Because large commercial engines burn gasoline, you will need an onboard fuel tank. The hot water burner also uses gasoline, oil, and diesel in a similar way. Therefore, any arrangement without substantial fuel tanks will require their addition before usage.

Tank of water
The trailer shown in the top photo includes a 200-gallon water storage tank that can supply a 4 GPM pump with water for 50 mins. Any power washing system that is genuinely mobile needs to have a sizable water tank. Water costs are usually referred to as the cost of water for a minimum of 1 hour. Therefore, you need a 480-gallon water tank if your pressure washer has an 8 GPM flow rate.

Consider the following additional water tank factors: Are you using a water tank as your primary supply or as a backup for the mains? If this is your primary source of water, you should make sure that the tank is as big as possible.

Cleansing tanks
The fastest way to clean is with chemicals instead of hot water. Because different surfaces require different chemical solutions, you will need to use different detergent tanks.
My Website: https://realisticpay.com/pressure-washing-truck-setup/