Notes

What ought to I shell out focus to when cleansing the dew position sensor in the glove box

Glove box h2o probe cleaning (only for washable probes)


one) Cause: If the water probe is not cleaned for a long time, some dirt will adhere to the area, affecting the detection.


glovebox ) Steps:


① Close the cycle and analyzer


② Established the operating strain to +five to + 8mbar


③Remove the drinking water probe and quickly blind the air outlet with a blind plate


<img width="425" src="https://www.etelux-glovebox.com/glovebox-2400.png" />

④Unscrew the steel protective cover on the entrance of the probe, clean it with deionized h2o, and then dry it with dust-cost-free paper, then moisten the probe with dust-totally free paper dripped with cleaning fluid, and apply evenly


⑤ Put it back in spot, open up the cycle, change on the analyzer right after 1 hour, and return to normal amount following 50 percent an hour.


note:


After the drinking water probe is cleaned, the glove box force is set to the unique value, and the cycle is turned on but the analyzer is turned on yet again following 1 hour, since after the h2o probe is cleaned, the probe area is cleaned with deionized water or 65% concentrated phosphoric acid wetting consists of h2o Indeed, if the analyzer is turned on prematurely, the h2o value will often be detected and exhibited to exceed the normal, so it is essential to circulate in the tank for a although and wait for the drinking water vapor to dissipate before turning it on again.


Homepage: https://www.etelux-glovebox.com/