Notes

Electrical Faults Which Are Prone To Affect The Home-Based Electrical System

This article is built to offer you some valuable information about common inadequacies within a domestic electrical installation.

Although electrical Inspections are often conducted by any competent electrician using the correct equipment, remedial works, particularly notifiable ones should be conducted with a part P qualified electrician and the appropriate building controllers notified.

Should your electrician be a part of one of the below competent persons schemes, they are able to self certify the installation.

Competent persons schemes members.

British Standards Institution (BSI)

EC Certification Limited / ELECSA

NAPIT Registration Limited (National Association of Professional Inspectors and Testers)

NICEIC Group Limited

Common fault No.1 - Lack of RCD protection on fuseboard.

One of the commonest defects with domestic electrical systems will be the not enough RCD protection on the consumer unit. The latest Wiring Regulations BS 7671 arrived to force after June 2008, requiring far more extensive provision for RCD (residual circuit protection) of both domestic and non-domestic dwellings. The practicalities of meeting those requirements for protection are varied and numerous to list within article but examples from the implications are below.

All power sockets sockets from 13Amp - 20Amp for use by 'ordinary persons' should normally be protected by a 30mA RCD.

In bathrooms as an example RCD protection is now necessary for all circuits.

In summary, you'll discover several approaches to fuse board design in order to meet the most up-to-date regulations, most of which utilise traditional RCD main switch consumer units and split load consumer units, whilst others depend upon the newest type of dual RCD protected consumer units. In general the use of RCDs and RCBOs has become greater as there are mostly a trend towards larger consumer units with additional ways available.

Common fault No.2 - Partial or incomplete bonding.

Electric shocks as a result of faulty appliances and charged metallic objects could be fatal. Therefore it is best all metallic things like gas and water pipes inside a property are properly earthed in order for electricity to get dispersed safely. Bonding may be the expression used allowing you to connect all metallic things that tend not to normally carry a current (pipes etc) within a property, and also to the mains earth in order to avoid electric shocks.

In each electrical installation, mains bonding conductors(earthing wires) have to hook up to the principle earthing terminal for the installation of these following items:

metal water service pipes

metal gas installation pipes

other metal service pipes and ducting

metal central heating system and air con systems

exposed metal structural parts in the building

lightning protection systems

Common fault NO.3 - Inappropriate fittings in bathroom.

For Electrical safety, bathrooms pose a higher risk of electrocution because of the proximity of water. Electrical appliances commonly found here should demonstrate higher numbers of protection in compliance with section 601 in the new wiring regulations.

Lighting

Extractor fans

Shaver sockets

Towel rails

Electrical equipment found in bathrooms should not be adversely effected by environmental factors.

electrician brisbane northside /steam

Drops of water

Sprays from showers

Website: https://www.cablerite.com.au/services