Notes

The Simplicity Of Keku Wall Panel Fixings
Have https://www.texturepanels.com.au/products/brick gone into a modern office block or even a shop and wondered what sort of wall panels have the symptoms of nothing holding them about the wall? Often there won't be any screws or connectors visible which can be holding these to the wall. So how is this effect achieved?
A number of years ago this process effect could have been unthinkable and also you might have found some kind of visible fixing at the pinnacle and bottom of the wall panels holding them about the wall behind, but this did look unsightly unless the screws heads were filled over.
However in filling them inside you had two problems, firstly obtaining a colour match with all the filler was quite difficult. Secondly should you filled them in this made the panels very difficult to remove in a rush, that may be a problem in case you needed to get to any electrical equipment or water pipes sat behind them in a hurry.
One German company recognised the need to have a very wall panel fixing system that allowed panels to get firmly fixed to some wall without having visible fixings showing, but in addition allowed these to be released quickly in the event from the need to have a panel off. This has proved to get an idea that shop fitters love using as it gives this type of clean look.
The Keku wall panel system works very by just having lightweight aluminium "I" cross section beams that are like mini RSJ beams in form. These come pre-drilled with holes and they are screwed to the real wall.
A load bearing frame component is then attached on the beam along with the relevant panel component attached on the panel, this then means the panel will then be slid into place with all the panel component clipping in to place with the frame component. This forms a link, which essentially locks the panel to the wall, but by simply sliding the panel upwards the constituents come apart releasing the panel.
The proven fact that the beams come pre-drilled for easy assembly does mean the frame components might be attached on the beams at a wide variety of heights. This in turn allows a lot of flexibility when hanging the wall panels.
The end result is wall panel fixings that may be fixed firmly, but invisibly in position but accommodate an incredibly high dimensional accuracy, with gaps which can be precise, yet may be varied in width.
Here's my website: https://www.texturepanels.com.au/products/brick