Notes

How To Apply Graphics: Striking Your Dirt Bike
There are so many ways to customize your dirt motorcycle, UTV, UTV, or motorcycle's appearance - graphics and decals are available in every color and design. It's fun to select the graphics that you like, but it could be a challenge to put them on when you're not sure what to do.

How to Install Dirtbike Graphics
Attack Graphics is a professional graphics shop that is specialized in powersports, and their graphic designers are experts in applying graphics to off-road vehicles. These are the steps needed to apply graphics in an easy method that ensures that the graphics will stick.

Dry Set Up
1. Clean your plastics, hands and work area. Clean your plastic on the machine's front and back sides. When you want to learn fruitful information about dirtbike graphics, you have to browse https://www.apzomedia.com/best-womens-dirtbike-riding-gear-fall-riding/ website.

2. Before applying before applying, trim the backing of the paper around the perimeter, making sure it is as close to the graphic as possible (without cutting off the graphic). The backing paper should be removed from the vents and bolt holes. Check the alignment of the vents, holes and curves as well as the edges of your graphic with the plastic.

3. Peel off half of the backing, being careful not to let dust or other debris to accumulate on the adhesive side. Cut the backing down the center in a horizontal direction for side plates, or vertically for front plates. Cut a half-inch-long strip from the first half of the backing. Apply the remaining backing to graphic, lining it up with edges and holes.

4. Align the graphic with the plastic in order to avoid the center strip sticking. After the graphic is properly aligned, you can attach the center strip to the plastic.

5. Peel off the backing paper from one side, and then hold the image up and away from the plastic. Apply the graphic slowly by sliding your finger back and forth across the graphic, pressing out wrinkles and air bubbles. It is possible to apply heat using an electric hair dryer or a heat gun in this procedure to remove wrinkles and air bubbles.

6. Remove the paper backing from the opposite half Apply the design as explained in step 4. For all other graphics, follow the same steps.

Wet Installation
1. Cleanse your hands, your plastics and work space. Clean the plastics on your machine's front and back sides.

2. Cut the backing of the paper as close as is possible to the graphic before applying. Remove the paper backing from the inside of the vent and bolt holes. Check that the lines of your holes, vents curves, edges, and the edges of your graphic against the plastic.

3. Apply a fine mist application fluid on your plastic.

4. Take the backing paper off your decal, and be certain that you keep the adhesive free of dirt, dust and debris. Spray the adhesive with a fine mist application fluid.

5. Apply the decal lightly onto the plastic, while filling the vent holes.

6. Once everything else is aligned properly, start with the center and employ a squeegee for moving the application fluid to the edges of the plastic.

7. To speed up dryingtime, it is possible to add heat to the squeegee by using a heat gun or hair dryer. It can also be used to smooth wrinkles and get rid of bubbles.

8. Clean, dry cloth to remove any excess liquid that has accumulated at the edges of the plastic.

9. To ensure adhesion, it is best to not ride your dirtbike or quad for at least 24 hours.
Read More: https://www.apzomedia.com/best-womens-dirtbike-riding-gear-fall-riding/