Notes

How To Install Dirt Bike Graphics
Our long-term partner for creating dirt bike graphics has been Substance Incorporated. Innovative and unrivalled passion for the marketplace, Substance Incorporated is a market leader in motocross graphics technology for screen and digital printers.

Before you begin

Check your plastics for damage, If they're scratched, scratched or have major damage it is worthwhile to consider replacing them. Before you start to install dirt bike graphics kit the dirt bike's plastics have to be in a reasonable / excellent condition.

To apply dirt bike graphics, you'll require:
Adhesive paper tape
paper knife / scissors;
hair dryer or heat gun;
degreasing agent, or alcohol and water combination
squeegee (optional);

Clean your hands. When you are preparing surfaces or using MX graphics, it's essential to wash your hands. Dirty or oily hands make it harder for your dirt bike graphics to adhere. If you really need to discover new information on dirtbike, you have to browse around here https://www.ebay.com/str/decallab?fbclid=IwAR1GW31Md9ok6Wgdi8nBEZxnUXFGI_yMztob3HbmdJiN6iVg2av6z09xIDI website.


Preparing surface
Before you start to Install dirt bike graphics, it is necessary to take off the old decals. You can use a hair dryer or heat gun to warm the old graphics for easy removal. Use a degreasing agent to clean the surface. It is crucial to clean any glue residue, oil or dirt that has accumulated from the old graphics. When applying motocross graphics on dirt bike plastics, they should be heated up. Plastics should not be kept in temperatures exceeding 15°C/60°F for more than a few hours.

Graphics
Your dirt bike's graphic (e.g. number plate). Apply the decal onto your plastic with adhesive tape. This will keep your decal in place. You are able to use the amount of tape you'd like.

Remove the backing paper from the background, and then cut it into pieces. Make sure you are aligned on the part that is to be covered. Touch one side of the graphic with your fingers to align it in the desired position.

You can create sections making use of your thumb or a squeezer to apply pressure to the graphic. Be cautious not to create wrinkles and bubbles. You have to work from the center out. You can remove the bubbles by gently peeling them off and then try again. Make use of the safety pin to blow out any air bubbles. Then smooth out the bubble section moving towards the edges of the graphic. The process can be repeated on the reverse part of the decal.

There are sharp lines in your plastic (e.g. Number plate on the exhaust pipe): A heat gun can heat the graphics, making them more malleable. Make sure not to heat too much!

We suggest employing a paper knife to remove excess sections or parts of the mx graphic covering bolts, access holes and vent slits.

Installation tips
Be patient and patient! Installing dirt bike graphics not as hard as it may seem.
A few hours prior to installation ensure that your plastics or dirt bikes in place and at temperatures greater than 15degC / 60 oF for a period of time.
At minimum 24 hours prior to riding to ensure that you have a good bond.
My Website: https://www.ebay.com/str/decallab?fbclid=IwAR1GW31Md9ok6Wgdi8nBEZxnUXFGI_yMztob3HbmdJiN6iVg2av6z09xIDI