Notes

Maintaining your furnace: Recommended tasks
Recommended Furnace Maintenance Tasks
In September, we are leaving behind the heat of the summer and gearing up for the cold of winter. Perform furnace cleaning and maintenance now in order to avoid being stuck in the cold with a damaged furnace. In addition to providing you with timely and quality HVAC maintenance, repairs, and replacements, Rooter Hero Plumbing is also happy to offer you some useful tips. The purpose of this article is to discuss some furnace maintenance recommendations. Hire a qualified technician by contacting us.

Clean the Burners

Be sure the electrical switch and circuit breakers are shut off before you begin working on the furnace. Besides cutting off the fuel supply, you should also shut off the power. Then, remove the combustion chamber door. https://canduplumbing.com/granada-hills-ca/water-heater-repair/ and the burners. Ensure that all dust is removed and look for any signs of soot. It is likely that poor combustion resulted in this fine black powder and that an HVAC technician is needed. Rooter Hero Plumbing is happy to help.

Clean the Blower

Remove the blower and vacuum the interior thoroughly. A small brush can also be used, but be careful not to damage the wiring or disrupt the counterweights on the fan blades. You should leave this work to technicians if you are not confident of working sensitively. An out of balance component can disrupt the unit's functioning.

Change the Furnace Filter
You get good, clean air in your home from the furnace filter, which also protects the fan, heating coil, and other components of the furnace from dust, dirt, and other contaminants. Check the owner's manual for guidelines on how and when to remove your furnace filter. Typically, you should change a fiberglass furnace filter once every two to four months, and a paper furnace filter once every three to four months.

Clean Other Components

Dust should be blown off the pilot or igniters on hot surfaces. It is best not to touch these parts at all. A drinking straw works well for cleaning them. Remove the flame sensor by pulling it out of its bracket. Put the sensor back in place after lightly cleaning its surface with a fine emery cloth.


Oil the Motor Bearings

If the caps need to be removed, wipe them with a clean cloth before removing them. Spritz each bearing with two to three drops of light machine oil. Do NOT overlubricate. Finally, put the caps back on.

When to Call for A Professional Technician

It is a complex and valuable unit with numerous sensitive components. The moment these parts begin to wear out and become damaged, Rooter Hero Plumbing is the company to call. If you are concerned about damaging the sensitive parts of the HVAC system, hiring an HVAC technician in Clairemont Mesa could also be a good idea. Candu Plumbing provides reliable, affordable, and accessible plumbing services. For https://canduplumbing.com/granada-hills-ca/drain-cleaning/ , call now.

Here's my website: https://canduplumbing.com/granada-hills-ca/drain-cleaning/