Notes

Installing a Fish Finder
Installing a fish finder does take some technical skill however, after some hard work plus some forethought it is possible to purchase a fish finder being a pro. The first item can be to take into account the location. Make sure to select a location which will allow enough space to route the wiring and also a surface for optimal viewing. Keep in my site that sunlight can on occasion create a fish finder display to show up dim. A flush mount kit can be acquired if installing on the panel or most units include a bracket that enables the unit to get removed if needed. Also, remember to install the unit in the place which will be relatively clear of water intrusion when possible. A high quality fish finder will resist most water but fostering to stop it all together will assure your brand-new fish finder gives you a lot of service.

The next step is to install the transducer. Time should be delivered to properly plan this as improper placement can result in a complete malfunction as well as the fish finder might not exactly read in any respect (make reference to owners manual for optimal placement.) Never cut the transducer cable try to mount the transducer so that it is parallel on the bottom of the vessel. Never mount inside a location that is certainly inside the path with the propeller. Make sure to supply sufficient water depth, usually just under the boat hull, if mounting around the transom. Take caution here, the fish finder might not read correctly while under way otherwise mounted below the hull. Also, in the event the boat is on a trailer ensure the mounting location will not be prone to damage when launching. One last important item, only use the proper sealant when drilling mounting holes below the river line. Depending in your installation, your fish finder will likely desire a few mounting holes drilled to mount the transducer. Now install the wiring harness and route the transducer cable. Take care when routing the transducer cable because keeping the wiring from other electrical wires will help minimize the potential of electrical interference. The display around the fish finder could show noise, as an example; turning over a wash down pump or live well pump. The electrical connections needs to be made while using the proper procedures found inside the installation guide from the manufacturer. Never connect wiring with all the assumption that one colors are for particular things! The standard wiring harness on a fish finder in most cases possess a black wire for a ground and a red for power but look at instructions (MEN).

Some fish finders have an overabundance of wires to power other components or communications with marine electronics. Never connect wires if you're unsure and constantly perform the proper research for your particular fish finder to successfully have a reliable wiring diagram. Overall installation also need to take into consideration that a fish finder is definitely an expensive machine in your boat. The wiring should basically be used for the purpose with the fish finder and many types of connections must be sealed well generating well. Any time holes are drilled they need to not be sealed with mounting screws alone, but also sealing compound. Check the manufacturer's suggestion inside manual of your respective fish finder to determine an approved sealant. Above all, make sure to read the owner's manual that accompanies a new fish finder. Don't forget to enjoy the good days, and search toward better days for the bad ones. The big an example may be one cast away.
Here's my website: https://www.marine-electronics.com.au/