Notes

Tips on how to Install and Remove Hydraulic Breaker
A Hydraulic Breaker, also identified as a carambolage hammer, can be a large mechanical device accustomed to demolish concrete, asphalt, or stone components. Hydraulic breakers are usually seen in road construction and are usually preferred because of their higher performance. Most mini excavators can get installed differently Hydraulic Breakers.

This content is about the particular installation and treatment of Hydraulic Breaker for Mini Excavator.

When piping the hydraulic lines on-base machine, it is important to understand the fundamental routine to which the particular piping belongs. After that the piping could be connected appropriately, properly and swiftly.
Check the piping lines for the particular correctness of many of these as pressure, flows or pressure damage, if the hydraulic pipe once happen to be installed inside the basic machine.

A pressure control valve offers to be installed if there is no stress control valve on the main handle valve in the foundation machine.

Set typically the hydraulic breaker about horizontal ground.
Eliminate the bucket from the base machine after disassembling the two pins
Move the base machine throughout the vicinity involving the hydraulic breaker, align the pinhole of the equip with the pinhole of the hydraulic breaker, then, insert typically the pins.
After the particular arm pin is definitely inserted, lift typically the boom, and place the hydraulic breaker on the wood blocks like 4-3-3. Extend the bucket cylinder, fit it to the pail link? s opening and insert the particular pins.
Install typically the stop rings, line-up the bolt openings and insert the particular bolts, mutually lock the double fanatic.
Stop the powerplant in the base equipment, turn off the key switch and relieve the air stress in the hydraulic oil tank.
Take out the union caps from the hydraulic breaker pipe in the arm end, and connect the hoses after disassembling typically the hose plug

Hook up the hoses towards the stop valve with both sides involving the arm.
Switch on the motor of the foundation machine, left typically the boom, operate typically the bucket cylinder plus check the hose of hydraulic breaker will be connected correctly.
Starts warmup the bottom machine.

Set the particular hydraulic breaker about clean and side to side ground. Lock how to install hydraulic breaker packing brake associated with base machine.
Quit the engine.
Convert stop valve to? OFF? position.
Detachment hoses from cease valves. Ensure little leakage occurs through hoses and prevent valves.
Apply union cap and stopper to hose ends fittings in order to avoid contamination.
Remove pins mending fasteners.
Remove limits.
When pins experience been withdrawn, maneuver operating joystick a little bit, to take the particular weight off leftover link pin.
Raise arm faraway from hydraulic breaker in order that hydraulic breaker may be carried away, or one other attachment mounted on-base machine.

Read More: https://jtexcavator.com/blog/how-to-install-and-remove-hydraulic-breaker-for-mini-excavator.html